User manual GEONAUTE BATTERY CHARGER 100

[. . . ] To charge the battery, connect one end of the USB cable to one of your PC's active USB ports, and the other end to your KeyMaze 300 GPS. When the KeyMaze 300 is fully charged, the battery indicator is completely full (if the device is on) or the words "BATTERY CHARGING COMPLETE" are displayed (if the device is off). Most malfunctions usually indicate that the battery is not charged. To extend battery life, ensure that you charge and discharge it as fully as possible. [. . . ] The clock screen displays time since exercise started (TRAINING TIME), distance covered (DISTANCE) and average speed since exercise started. The clock screen shows the time (TIME OF DAY), your average speed since exercise started (AVG SPEED) and instant altitude (ELEVATION). The stopwatch mode calculates and records your training data (location, speed and distance) i Important: remember to check that the device is receiving the GPS signal (satellite symbol displayed continually, not flashing) at the start of your training. If not, the data recorded may be incorrect. Press OK to start or stop the exercise stopwatch (the ESC button is also used to stop the stopwatch when in use). When the stopwatch is stopped, press ESC/LOOP to reset it to zero. The device then gives you the option of saving your journey (SAVE THIS TRAINING DATA YES/NO). It fastens to your forearm using a Velcro strap system. The aerial is under the plastic cover, near the screen. for optimum performance , the top of the device should be facing the sky. The more it is oriented towards the sky, the better the reception will be. Use this option to disable detection of the signal when it cannot be received correctly or to save the battery. I Make sure you activate GPS signal reception when you want to record a route. 3 SAVE WAYPOINT Select this option then press OK to record a WAYPOINT. Next, select the alarm settings using the VIEW/SET arrows to move the cursor to the figures to be modified. Next use OK to open a window with the values to be modified. With the SPEED ALERT option you can programme upper and lower movement speed limits. the device will beep if you go over one or the other. Select the alarm mode you want using the VIEW/SET arrows and then OK. After pressing OK again, a window appears giving you the choice between: No alarm: OFF. 4 FIND WAYPOINT Select this option to find a waypoint you have already recorded in order to return there. Select LIST ALL to choose the waypoint from the list of all waypoints recorded on the device. [. . . ] 8 FACTORY RESET With this option you can restore the device's original settings. Select the option then confirm using OK or press ESC to exit the mode without resetting. 10 UPDATE FROM PC This option allows you to update the Firmware (the KeyMaze 300's internal software) from your PC. Click YES to confirm your choice then connect the device to your PC using the USB cable provided. [. . . ]