User manual GEONAUTE MW100

[. . . ] The station also includes a clock and an alarm. PRECAUTIONS FOR USE the device with care; it or · Handle dismantle the device. do not dropwouldsubject it to significant impact. and Doing so void the Geonaute warranty · Do not could damage the device. This does not apply to changing the batteries, as described under the heading "Changing the Batteries. " 12 13 EN · Please read instructions carefully before use and use the device under normal operating conditions. is a flat, sta· Thesurface or fasten it to theItwalldesigned for indoor use. [. . . ] When the batteries and electronic product are worn out, return them to a recycling or collection facility. This treatment of your electronic waste will protect the environment and your health. FIRST USE It is very simple to start up this portable weather station. Unscrew the cover for the battery compartment with a precision Phillipshead screwdriver. Insert 2 CR2032 3V batteries with the terminals oriented as shown on the inside. Close the cover without pinching the seal. Install the table stand or belt clip, depending on required usage : 4. Put the battery compartment cover back on and re-tighten. Note: Replace the batteries as soon as signs of weakness appear. An incoherent, weak, or flickering display may be a sign of premature battery depletion. · NAVIGATION SYSTEM This device features 3 display lines to facilitate reading. Each line has a precise function: Weather forecasts and barometric trends Temperature and humidity level Time, alarm, calendar. · · · EXPLANATION OF EACH MODE Table stand Belt clip No further startup procedure is necessary. Note: The first temperature and pressure measurements will be valid approximately 15 minutes after battery installation. The calculation is based on barometric readings for the preceding 24 hours. There are 5 possible icons for indicating trends : Sunny Sunny with cloudy periods Cloudy Rainy Storm High and low temperatures The high and low temperatures are recorded automatically as soon as they are measured. To display the high temperature, press the Min/Max button once. Repeat the same procedure to return to the current temperature display. To erase the memory, press the Min/Max button and hold it down for three seconds. An audible beep confirms that the data were erased. Then if you press the MIN/MAX button, the high and low temperatures will be the same as the current temperature. · · · Displaying the phases of the moon IMPORTANT: Meteorological forecasts are not an exact science!No professional institute in the world is capable of 100% accuracy. The station's forecasts should be considered an indication only. If you must embark on an extended or dangerous outing (sea, mountains), confirm the forecasts of the WS700 mobile unit by contacting your local meteorological institute. Also, on the sea or in the mountains, weather conditions can change extremely rapidly, creating a risk to life. [. . . ] Press " " for 2 seconds to lock or unlock the keys. An icon appears or disappears, depending on whether or not the function is engaged. MAINTENANCE Here are a few tips for the maintaining your weather station: 1. If the unit comes into contact with water, dry it immediately with a soft, lint-free cloth. Never use an abrasive or corrosive cleaner on this device. [. . . ]