User manual GEONAUTE SYNKRON 200M

[. . . ] It is very important to follow the instructions STEP by STEP when using the station for the first time. Do not skip any steps or do them out of order. [. . . ] The following checklist must be followed in the right order. Each item on the list is important. Place all the items on the same table, away from any sources of interference (televisions, cell phones etc. ). 1. 4 new LR6-AA 1. 5 V batteries are included for use with the station. The batteries are not installed in the device. 2 new LR3-AAA 1. 5 V batteries are included for use with the sensor. The batteries are not installed in the device. Change the parameters with the arrows located on the back of the device and switch form one parameter to another by pressing on MODE (see relevant section). 3 - Press the reset button of the sensor. 4 NEW_NOTICE_SYNKRON 200M_RAPIDE_TLL 21/07/05 19:15 Page 5 4 - Carefully reinsert the seal of the sensor, taking care not to damage it. 14 - Weather Next, close the sensor's battery cover with the 4 Phillips head screws. 15 - Place the station and the sensors in their permanent locations. Make sure to position the sensors upright and not to condition settings: the weather condition display does not require any adjustments. It starts with "cloudy weather" and gradually adjusts within 24 hours. However, if after 24 hours there is a large discrepancy between local weather and the weather displayed on the station, you can force the station to initialize by pressing with a fine tip on the station's RESET button. In this case, steps 9 to 12 have to be redone exceed the distances recommended in the instructions, depending on whether there are obstacles between the sensor and the station or not. 5- Position the sensor in an upright position on the table, using the table stand provided. 6 - Optional: Installing additional sensors. 7 - Insert the batteries in the station according to the indicated polarities. Close the cover and put the base back. Verify that the station is displaying something. If it is not, check the position of the batteries. Take a second sensor and repeat steps 1 to 5 in the exact same order, choosing a free channel (CHANNEL) for each additional sensor (Step 2). [. . . ] If it is not, check the position of the batteries. Take a second sensor and repeat steps 1 to 5 in the exact same order, choosing a free channel (CHANNEL) for each additional sensor (Step 2). Fill in the information on the table in step 2 to identifyeach sensor and its channel number. 16 - Scroll through the various outdoor temperature channels by pressing on the CHANNEL button and verify that the temperature measured by each of the sensors is displayed on the screen. [. . . ]