User manual GEONAUTE WATCH KRONYS 500A

[. . . ] Avoid any contact of the pedometer with water, it is not waterproof. · Do not submerge the appliance in water. If the appliance comes in contact with water, dry it with a dry, soft and lint-free cloth. · Do not clean the appliance with abrasive or corrosive products. · Avoid exposing the appliance to shocks, dust, excessive temperatures and humidity. [. . . ] Sensitivity switch Increases or decreases the appliance's sensitivity for pedometer measurements. Batteries compartment Insert two LR44, 1. 5v batteries. Finger emplacement For pulse-rate measurement. Cover opening button Press it to open the protection cover. Belt clip Allows clipping the appliance on a belt or on clothes. 24 First use Inserting the batteries The appliance operates with two LR44, 1. 5v batteries On first use: 1. Gently press and remove the battery compartment's cover. Place the cover back on again The low battery icon will remain visible as long as the batteries are low and need to be changed. When the batteries are worn out, replace them with two new LR44, 1. 5v batteries. Note : Protect the environment by depositing worn out batteries in appropriate collection sites. Press the MODE button to switch between the STEP, DIST/TIMER and CAL/TIMER display modes. In STEP mode, press the MODE button for 2 seconds. Press the RESET button without releasing it for faster setting. 27 EN Notice Dista F700tll. qxp:Mise en page 1 4/01/07 18:02 Page 28 4. Press the RESET button to set the weight. Press the RESET button without releasing it for faster setting. Press the MODE button to confirm the setting and exit the setting mode. Using the step meter The pedometer function counts the number of steps that a person covers on a distance. Press the MODE button to switch between the STEP, DIST/TIMER and CAL/TIMER modes. Press the RESET button, the steps meter resets to zero. Setting the sensitivity of the steps measurement sensor: use the setting switch to adjust the appliance's measuring sensitivity. To find a suitable sensitivity level suited to the type of step, several different settings will have to be tested Using the distance and calories calculations This appliance calculates the total distance covered and the number of calories burnt. Press the MODE button to select the DIST/TIMER display mode. The screen's upper line gives the total distance covered. [. . . ] This means that the appliance is correctly detecting the heartbeats. The appliance displays your pulse-rate in heartbeats per minute at that moment. If, for any reason whatever, the appliance cannot measure the pulse-rate the display automatically returns to the previous display mode. To exit the pulse-rate calculation mode, press the PULSE button to return to the previous mode. 30 31 EN 2. [. . . ]