User manual GERICOM 3200

[. . . ] 1 2 3 4 5 6 7 8 i Preface: legalaties 1 2 3 4 5 6 7 8 NOTICE The company reserves the right to revise this publication or to change its contents without notice. Information contained herein is for reference only and does not constitute a commitment on the part of the manufacturer or any subsequent vendor. They assume no responsibility or liability for any errors or inaccuracies that may appear in this publication nor are they in anyway responsible for any loss or damage resulting from the use (or misuse) of this publication. This publication and any accompanying software may not, in whole or in part, be reproduced, translated, transmitted or reduced to any machine readable form without prior consent from the vendor, manufacturer or creators of this publication, except for copies kept by the user for backup purposes. Brand and product names mentioned in this publication may or may not be copyrights and/or registered trademarks of their respective companies. [. . . ] Using a CD-ROM drive on another computer, navigate to the d:\drivers \DOS\CD-ROM or d:\drivers \DOS\DVD-ROM directory. Copy the folder for your module onto a 1. 44MB floppy. Install the CD-ROM or DVDROM module in the Device bay. Connect the FDD adapter cable to the FDD module. Connect the FDD + Adapter cable to the parallel port on the rear panel. Insert the floppy containing CDROM driver into the FDD. Switch to drive A:\ and open its driver directory, and type: SETUP. EXE 6. As each page appears, press Y or Enter to confirm the settings. If you don't want to install the driver in the default directory (C:\ATADVD), when the "Specify the directory. . . " dialog box appears, use Backspace to delete the current name, then type in your preference. Remember to start the directory name with C:\. When you get to the "Specify the parameter. . . " page, make sure the ( )/D [MSCD000] switch has an asterisk (*). When the installation is complete, remove the floppy disk and reboot your computer. Windows 95-98 Windows NT4 Follow steps 2 to 5 of the DOS installation. These operating systems automatically detect and configure the CD-ROM drive. The start-up floppy which comes with them should also be able to configure the CD-ROM. It they can't, install a version of DOS and the CD-ROM driver as described above. Then follow the installation utilities for the operating system you plan to use. As the installation progresses, the operating system will replace, or modify our CD-ROM driver. < 3­ 8 Device Bay: DVD setup DVD-ROM Setup (Windows 9x only) If you don't install drivers and application software, the system "sees" the DVD as an ordinary CD-ROM. Make sure the following drivers are installed: USB (page 2-18) Video (page 2-10) Audio (page 2-12) 2. Insert the CD-ROM with the DVD utility software. Go to the Start menu, click on Run. . . >Browse. . . Click on Open, Yes or OK as you follow the instructions. * Windows 98 allows limited region changes. [. . . ] (3) The preparation of the system for normal operation. S-video (Super-video) A higher standard video technology. 5- Glossary: U ­ V pin connectors have separate channels for luminance (Y) and color information (C) as well as Red, Green and Blue. TCP/IP Transmission Control Protocol/Internet Protocol. [. . . ]