User manual GIANT BICYCLES CITYSTORM

[. . . ] CITYSTORM USER GUIDE Congratulations on your purchase of a GIANT Citystorm. GIANT Citystorm represents the latest in design and engineering, and also requires special care. [. . . ] Step3: Press the button B to confirm the setting and move to the next digit to be set. Step4: Set each digit in order from date to time. Step5: After the minutes have been set, press the button A to return to the normal display. Step 2: mark Then release the lock from the bike. Step 3: After deciding how to lock the bike, push the lock in and turn to the lock position. How to replace the battery? Step 1: Loosen the stem watch fixing bolt with 3mm Hex key. Stem watch fixing Bolt Tightening torque: 1. 9-3. 4Nm Step 2: Push the stem watch up with 3mm Hex key. Warranty Please refer to the Giant Owner's Manual or visit our website: www. giant-bicycle. com for complete provisions of the warranty. Step 3: Loosen the cover fixing screw with screwdriver. Step 4: Replace the battery (LR921) with a new one. ! CAUTION The battery has polarity (+/- sides), so be sure to install the battery with the + side upward as shown in the diagram. 2 CITYSTORM SERVICE INSTRUCTION Read these instructions carefully before using, and follow them for correct use. Stem watch Front light How to disassemble the front light Pull out the front light from the head tube. Front light Step 1: Rear light Lock Step 2: Disconnect the front light from the connector. Front light How to replace the battery Step 1: Turn 90° counterclockwise with a coin to loosen the battery holder How to assemble the front light Note: You must install the front light first before install the handlebar stem. Step 1: 150mm Rotate the front fork and pull out the wire at the same time, make sure the length > 150mm. Battery holder Step 2: Take out the battery holder from the stem Step 2: Install the handlebar first and then connect the front light connector. Battery holder Step 3: - Battery Replace with new battery (AA SIZE). Step 3: Install the front light to the head tube; make sure the button is at the top position. + ! CAUTION The battery has polarity (+/- sides), so be sure to install the battery with the + side upward as shown in the diagram. Button 1 Button CITYSTORM SERVICE INSTRUCTION Stem watch How to use stem watch? Rear light How to replace the battery Step 1: B A Take out the cover with coin. A: SET B: MODE Method of displaying the date: Press the button A to display the DATE. Method to display the time: Press the button A twice to display the time. Method of setting: Step1: Press the button B twice to enter setting mode. Step2: Press the button A to change the value. Step3: Press the button B to confirm the setting and move to the next digit to be set. Step4: Set each digit in order from date to time. Step5: After the minutes have been set, press button A to return to normal display. Step 2: Replace with new battery (SIZE AAA). + - + ! CAUTION The battery has polarity (+/- sides), so be sure to install the battery as shown in the diagram. How to install the rear light onto saddle How to replace the battery? Step 1: Bolt Step 1: Loosen the rear light fixing bolt with 4mm Allen key. Remove the rear light and fixing link. Loosen the stem watch fixing bolt with 3mm Allen key. [. . . ] Tightening torque: 4. 9-7. 8Nm 1688 Bolt Installation of the front fork Step 2: Step 1: Wire 1688 Pull out the lock Insert the front fork into head tube and pull out the wire for the front light from the head tube. Step 3: Repeat Steps 1~2 in reverse to install the new lock Warranty Please refer to the Giant Owner's Manual or visit our website: www. giant-bicycles. com for complete provisions of the warranty. 3 [. . . ]