User manual GIANT BICYCLES CONTINUUM

[. . . ] B) (New magnet with cross gap fit to all wheel spokes both aero and round). Adjust the relative position between the sensor and the magnet. Align the center of the MAGNET to either of the sensing zones S . Make sure the GAP between the magnet and the sensor is within 4mm (1/6 inch). [. . . ] Remember to pay attention to the road while riding. TROUBLE SHOOTING Check the following before taking unit in for repairs. PROBLEM CHECK ITEMS REMEDY Main Unit: 1. Is the battery dead?No display 2. Is there incorrect battery installation?2. Be sure that the positive pole of the battery is facing the battery cap. Is it at the recalibrating or 12HR Speed or clock setting screen?Are the contacts between the main data unit and the bracket poor?3. Are the relative positions and gap of sensor and magnet correct?Irregular display LCD is black Display is slow Was the main unit under direct sunlight when not riding the bike for a long time?1. Refer to the adjusting procedure and complete the adjustment. Refer to (Fig. B) and (Fig. C) and readjust data correctly. 5. Refer to "CALIBRATION" and enter correct value. Refer to the "MAIN UNIT SETUP" and initiate the computer again. Place main unit in the shade to return to normal state. No adverse effect on data. Unit will return to normal state when the temperature rises. 1 MAIN UNIT SETUP CALIBRATION (UNIT SELECTION & CIRCUMFERENCE SETTING) LCD SEGMENTS AUTO TEST 3 2 SEC 2 SEC MODE END SETTING 2 DST MODE CLK TM AVG MAX T_TM ODO / ODO MODE C mm Setting 6 SEC RECALIBRATIONS 4 SEC 4 Calibration 6 SEC 2 SEC CLOCK SETTING 4 SEC 5 CLOCK SETTING 6 SEC 6 WHEEL SIZE CHART TOTAL 6 SEC Complete Setting TOTAL 6 SEC Complete Setting Continuum 5 has 5 FUNCTIONS: SPD, DST, ODO, CLK, SCAN. Contimuum 8 has 8 FUNCTIONS: SPD, DST, ODO, CLK, AVG, MAX, TM, SCAN D. MAIN UNIT SETUP (Fig. 1) COMPUTER SET-UP 1. Be sure to press the All Clear (AC) key 4 to clear all stored data and initiate the computer before using it or when replacing battery otherwise the unit may malfunction. The LCD display will be tested automatically after the All Clear key is pressed. Press the "MODE" button 2 to stop the LCD test, then the flicking "KM/h" and "c2155" will be displayed. Press the "MODE" button to select "KM/h" or "M/h"(Mile/h). Hold the "MODE" button until the blinking digit is changed to the digit "2" of the c2155 to recognize either KM/h or Mile/h as desired. 5) or refer to the quick reference table provided in the manual for your bicycle. [. . . ] A quick press of the "MODE" button advances the blinking digit by 1. To change the blinking digit, hold down the "MODE" button until the blinking digit moves to the next digit. Hold down the "MODE" button until (about 6 seconds) it exits out of the setting to store the desired data and complete clock setting. F. BUTTON and NORMAL OPERATIONS AUTOMATIC START/STOP 1. [. . . ]