User manual GIANT BICYCLES L IL GIANT TRICYCLE 10 AND 12

[. . . ] Before assembling your Li'l GIANT tricycle all of us at GIANT strongly encourage you to CONSUMER PRODUCT SAFETY COMMISSION (CPSC) FOR ANY CHILD USING THIS RIDE-ON WARNINGS!DO NOT ALLOW CHILDREN TO RIDE THIS TRICYCLE WITHOUT ADULT SUPERVISION!This ride-on toy is designed and manufactured for OFF STREET USE ONLY!It is not equipped with a braking device. [. . . ] If you are not absolutely sequence as described. The total time for assembly should be between 30 minutes and 1 hour. Inspect the tricycle before it is ridden, and be sure that all parts are assembled securely. Remove the tricycle and all of its parts from the carton prior to assembly (see Fig. MAINTENANCE: Your Li'l GIANT is a quality tricycle. It has been constructed utilizing quality components and fasteners. Contact your local Authorized GIANT Retailer for replacement parts and service. With periodic maintenance, common sense usage, and care this tricycle can that everything is securely tightened. Check the handlebars to make sure that they secure. Replace any broken or worn parts as necessary. Figure 1 and lay them out on a flat surface. Compare the contents of the carton with the diagram provide many years of riding enjoyment. Periodically check all of the fasteners to insure STEP #1 ­ Install Front Wheel/Fork Assembly Install the Front Wheel/Fork Assembly (item#1) by inserting the threaded steerer tube of the front fork into the bottom opening of the head tube on the front end of the frame until the top of the steerer tube passes through the head tube and the remainder is exposed above the top of the head tube. Check the wheel retainers at the bottom of the front fork using 2 ­ 5mm hex wrenches (not included) to insure that they are securely tightened. STEP #2 ­ Install the Handlebar Assembly and Headset Retainer Hand thread the Headset Lock Ring (item# 2) onto the fork steerer tube until it is snug against the upper headset cup at the top of the head tube. The Headset Lock Ring should be no more than hand tight and the front fork should turn freely in the head tube without rattling. If the fork does not turn freely then you should back the Headset Lock Ring off until it does turn freely. If the fork rattles or feels loose in the head tube then you should tighten the Headset Lock Ring further until the fork feels solid in the head tube, but still turns freely. Now install the Steerer Tube/Stem Clamp (item# 3) by sliding it over the top of the rider will be seated. steerer tube. Position the clamp slot towards the front of the bike ­ away from where the Insert the stem portion of the Handlebar Assembly (item# 4) into the steerer tube until the hashed line above the words "Minimum Insertion" (stamped on the Handlebar Assembly) is below the top of the steerer tube. [. . . ] If the wheel spins freely but rattles or wobbles on the axle, tighten the nut until the wheel spins true. c) Repeat the wheel installation procedure for the second rear wheel. STEP #4 ­ Install the Saddle and Clamp Assembly a) Install the Saddle and Clamp Assembly (item# 5) by sliding it onto the saddlemounting spur on the frame. b) The fore/aft position of the saddle can be adjusted by sliding the Saddle and Clamp Assembly along the saddle-mounting spur. In addition, the angle of the a 6mm hex wrench ­ tighten bolt on the Clamp Assembly securely. [. . . ]