User manual GIANT BICYCLES WARP BIKES-2001

[. . . ] The WARP bikes are designed for sports and recreational use. Rear travel 4". Size A B C D E F G H I Top Tube (measured horizontally) [mm. ] Seat Tube [mm. ] Seat Angle Head Angle B. B. Drop [mm. ] Chain Stay [mm. ] Fork Rake [mm. ] Trail [mm. ] Wheel Base [mm. ] Rear Travel [mm. ] S - 16. 5" 560 420 M - 18. 5" 580 470 73 degrees 71 degrees 15 430 38 76 L - 20. 5" 600 520 1047 1069 105 1091 TOP INDEX 2. REAR SUSPENSION SYSTEM WARNING: Improper adjustment of rear suspension shocks can result in unstable conditions or loss of control. The drawing below shows the rear shock. a . [. . . ] To adjust the pre-load on the coil-spring shock is simple. Looking at the front of the shock, facing the rear of the bicycle, follow these procedures: For a firmer ride while descending, hill climbing or smooth surfaces, turn the pre-load adjusting ring clockwise to compress or load the spring. For a softer ride while riding cross country, turn the pre-load adjusting ring counter-clockwise to relax or unload the spring WARNING: NEVER COMPRESS THE SPRING SO FAR AS TO LEAVE LESS THAN ½" OF THREADS SHOWING. IF THE PRE-LOAD YOU REQUIRE ALLOWS LESS THAN ½" OF THREADS SHOWING (BETWEEN KNURLED COMPRESSION RING AND THE PRE-LOAD SPRING WASHER) YOU MAY REQUIRE A HIGHER RATED SPRING. CONTACT YOUR GIANT DEALER FOR OPTIONAL REPLACEMENT SPRING. Standard shock spring rates and recommended rider weight ranges. Below is a chart showing the standard spring rates, and the recommended spring rates for different riders' weight (Shock model GTM-7, length 165 mm. ). Spring rate 650 lb/in 800 lb/in 1000 lb/in Range weight rider 5070 kg (110154 lb) 7090 kg (154198 lb) 90110 kg (198242 lb) Softer and stiffer spring rates are available for all rear suspension shocks through your Authorised Giant dealer. For service in your country please contact a local Authorised Giant dealer or the Giant Importer in your country. TOP INDEX 2-2. SAG is the amount of coil spring pre-compression that is required to compensate for the riders weight and allow the bicycle to perform as it was designed to. To properly set the SAG, you will need a screw driver, measuring-tape and/or calliper. Set the saddle to the correct height for your riding style. Attach all accessories, water bottles etc. Dress as you would for a normal ride, including helmet, cycling bag, etc. Measure the distance (L) between the main cylinder and the Pre-load spring washer of the rear shock. Step 2. Use a screw driver or the like to slide the bumper of the shock against the main cylinder of the rear suspension. Bumper Step 5. Step 6. Cylinder Sit on the bicycle with your feet on the pedals in your normal riding position. Come off from your bike without causing too much movement in the bike. Check the rear shock and you will see that the bumper has been moved along the piston. Measure the distance between the main cylinder and the bumper. 1/3 ~ ¼ of the dimension L measured during step 3. [. . . ] Parts such as seals, elastomer bumpers and bearings can be adversely affected by use, dirt and ultraviolet radiation. The rear shock unit should be returned to an authorised Giant dealer every year for inspection. DO NOT use high-pressure water or air hoses to clean bike. This can force dirt into areas, which may cause damage. [. . . ]