User manual GIGABYTE FA1UB

[. . . ] To not ify any person of such revision or c hanges. E1 G-MAX TM Flex ATX Series Us er's M anual Prefa ce This system unit is designed to be st able, safe, and easy to use. The sys tem can be upgraded and expanded in function easily if c orrect procedure is followed. For your own safety and t o avoid accident al damage to your system, please ensure you follow the following precautions: Follow all the warnings and instructions m arked on the products. [. . . ] E4 G-MAX TM Flex ATX Series Us er's M anual 3. CPU In this section you will find t he gis t of CPU installation. Before inst allation, lift up t he lever and align the cut of the CPU with the marking on the socket. Pull down t he lever to lock the CPU on the s ocket aft er inst allation. Apply t hermal grease to the t op of the CPU. Therm al grease should cover the entire s urface of t he integrat ed heat spreader. M ake sure that you should keep the cooler tight against the CPU to obtain the best cooling perform ance. Connec t fan power connector to CPU FAN on t he motherboard. For I ntel Pe ntium CPU Pin Lever and Intel Celeron proce ssors Apply thermal grease to the top of the CPU properly. Click cooler lock on the pin at sides of CPU socket. Install cooler on top of CPU B. For Intel Pentium 4 proce ssors CPU Pin Lever Apply therm al grease to the top of t he CPU properly. P. E5 G-MAX Power Supply TM Flex ATX Series Us er's M anual Install cooler on top of CPU Click cooler lock on t he pin at sides of CPU socket. Set CPU clock frequency in BIOS Setup if needed, see Motherboard Manual for details. 4. M em ory Notches at sides of m odule SDRAM Position not ches. Make sure that the notches should align the pin on m emory slot on the m ot herboard P. E6 G-MAX Notches at sides of m odule TM Flex ATX Series Us er's M anual DDR Position not ches. Make sure that the notches should align the pin on m emory slot on the m ot herboard In this section we will guide you to install m emory module. First, make sure the position notches at the bott om of the m odule should align to t he pins on t he module sockets on the m ot herboard, then push the module downward until the locks hook up not ches at s ides. Locks: make sure they hook up t he notches at sides of module 5. Insert the HDD into the frame and posit ion the sc rews accordingly. P. E7 G-MAX TM Flex ATX Series Us er's M anual 6. Connect the IDE cable included in t he accessory box to t he connector on the hard disc. Make s ure that the RED wire on the ribbon should be connected t o PIN 1 of hard drive. Connec t power connector t o the hard disc. Connect to HDD dis c Power connector 8. [. . . ] E14 G-MAX TM Flex ATX Series Us er's M anual For those models with SPDI F only User's Guide for Digit al CD audio 1. Insert the Driver CD that was included in accessory box into your CD-ROM. If the digit al CD audio can't output norm ally after audio driver is updated, please operate st ep by step as below. (A) Click on Start Settings Cont rol Panel (B) Selec t "System Propert ies" P. [. . . ]