User manual GIGABYTE G-POWER II PRO INSTALLATION

[. . . ] Before use, please remove the bottom protective layer of the cooler. Please make sure the computer is turned off and its power disconnected prior to installation. Warranty Item <Warranty coverage does not include the following> Incorrect method of operation or use of product not for intended use Operational use beyond the advised standards (eg. overclocking) Inability to install the product as a result of incompatibility with the motherboard used Damage of product as a result of other product components Any form of alteration to original product A faulty product that leads to harm or damage to other products Damage caused by natural disasters (eg. [. . . ] earthquake, fire, flood) Products with a warranty sticker that is removed, torn or unreadable Due to the weight of the cooler exceeding normal standards, please remove the cooler before computer transport to prevent damage to the cooler itself as well as prevent problems during installtion. -5- GH-PDU21-MF English Installation Instructions for Fan Control Box & Power Cable Connector for 3. 5 Fan Speed controller Power Cable connector Fan Control Box or Power connector for Cooler Connect the other end of the power cable to the 3-pin CPU fan header on the motherboard. Connect the other end of the power cable to the 4-pin CPU fan header on the motherboard. (LGA775) GH-PDU21-MF -6- English Power Installation and 3. 5" Fan Speed Controller Installation Figure 1 Securely hold the 3. 5" fan speed controller bracket in place with the screws provided(Figure 1-1). Figure 1-1 Figure 1-2 Figure 2 Connect the cable connector of the 3. 5" fan speed controller to the fan control box (Figure 2-1). Figure 2-1 Figure 3-1 Figure 3 Connect the power cable connector of the cooler to the fan control box (Figure 3-1). Figure 4 Assure that one end of the power cable included with the GH-PDU21-MF cooler is connected to the fan control box (Figure 4-1). Connect the other end to the CPU fan header on the motherboard. (Figure 4-2). -7- Figure 4-1 Figure 4-2 GH-PDU21-MF English Power Installation and PCI Fan Speed Controller Installation Figure 1 Disassemble the turn knob, bolt and fan speed controller from the 3. 5" bracket and reassemble these parts onto a PCI bracket in sequence. Figure 2 Place the PCI bracket with the fan speed controller in the selected PCI slot. Part B: Tightly contact the cooler bracket. Part C: Secured to the retention mechanism hook. Figure 3 Secure Parts A, B, and then C of the clip to the retention mechanism. Assure that Part C is secured to the retention mechanism hook on the same side as the heat pipes. Figure 3-1 Figure 3-2 Figure 4 Repeat the steps in "Power Installation and 3. 5" Fan Speed Controller Installation (Figure 2-1~Figure 4-2)". The installation is now completed. - 10 - Figure 1-1 C B A Figure 1-2 Figure 2 Figure 4 GH-PDU21-MF English Installation Instructions for AMD AM2 (940) / K8 (939 / 754) Clip Figure 1 Please add an adequate layer of heat sink paste on the surface of the CPU. Figure 1-1 Figure 1-2 Figure 2 Figure showing the correct installation of the cooler atop the CPU. [. . . ] Figure 1-1 Figure 1-2 Figure 2 Figure showing the correct installation of the cooler atop the CPU. Figure 3 Align the three insert spaces of the clip with the three juts on the CPU socket and then push firmly downwards to hold the clip in space. If AM2, only need to hook up the middle of protuberant point. [. . . ]