User manual GIGABYTE GA-5AA

[. . . ] 5AA USER'S MANUAL ¯ Support Intel Pentium, MMX, Cyrix/IBM 6x86MX, MII, AMD K6, K6-2, K6-III, IDT Winchip 2, IDT Winchip 3 & RISE MP6 CPUs. ¯ Support parity check or ECC function. ¯ Support fully AGP 1. 0 specification. ¯ Support switching mode voltage regulator on board (1. 3V~3. 5V). [. . . ] The RESET switch is a 2 PIN connector and should be installed to RES on mainboard. 3. 11. GREEN FUNCTION INSTALLATION There is one jumper for the purpose of power saving, GN, to indicate the power saving function . This mainboard uses the existing power LED as ACPI LED . If the ACPI LED is blinking, the system is in green mode. The GN switch will force the system into green mode . 3. 12. PERIPHERAL DEVICE INSTALLATION After installation of the device and setup of the jumpers, the mainboard can be mounted into the case and fixed by screw. To complete the mainboard installation, the peripheral devices could be installed now. The basic system needs a display interface card and a storage device. If a PCI - Bus device is to be installed in the system, any one of three PCI - Bus slots can be used for Slave or Master PCI - Bus device. After installing the peripheral device, the user should check everything again and prepare to power-on the system. 3-8 5AX D-1 BIOS Configuration 4. BIOS CONFIGURATION AMI's BIOS ROM has a built-in Setup program that allows users to modify the basic system configuration. This type of information is stored in battery-backed CMOS RAM so that it retains the Setup information when the power is turned off. 4. 1. ENTERING SETUP Power ON the computer and press <Del> immediately will allow you to enter Setup. The other way to enter Setup is to power on the computer, when the below message appears briefly at the bottom of the screen during the POST (Power On Self Test), press <Del> Key or simultaneously press <Ctrl>, <Alt>, and <Esc> keys. YPress DEL to enter SETUP. If the message disappears before you respond and you still wish to enter Setup, restart the system to try again by turning it OFF then ON or pressing the "RESET" bottom on the system case. You may also restart by simultaneously press <Ctrl>, <Alt>, and <Del> keys. 4-1 5AA 4. 2. CONTROL KEYS Up arrow Down arrow Left arrow Right arrow Esc key Move to previous item. Main Menu - Quit and not save changes into CMOS Status Page Setup Menu and Option Page Setup Menu Exit current page and return to Main Menu. Increase the numeric value or make changes. Decrease the numeric value or make changes. General help, only for Status Page Setup Menu and Option Page Setup Menu. Restore the previous CMOS value from CMOS, only for Option Page Setup Menu. Load the default CMOS value from BIOS default table, only for Option Page Setup Menu. Save all the CMOS changes, only for Main Menu. PgUp key /+ PgDn key /- F1 key F2 key F3 key F4 key F5 key F6 key F7 key F8 key F9 key F10 key 4-2 BIOS Configuration 4. 3. [. . . ] SAVE & EXIT SETUP Figure 4. 12: Save & Exit Setup Type "Y" will quit the Setup Utility and save the user setup value to RTC CMOS RAM. Type "N" will return to Setup Utility. 4-34 BIOS Configuration 4. 16. EXIT WITHOUT SAVING Figure 4. 13: Exit Without Saving Type "Y" will quit the Setup Utility without saving to RTC CMOS RAM. Type "N" will return to Setup Utility. 4-35 5AA 5. [. . . ]