User manual GIGABYTE GA-6VM7A

[. . . ] FCC Compliance Statement: This equipment has been tested and found to comply with limits for a Class B digital device , pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] The system will halt and the following error message will appear in the mean time. You can run anti-virus program to locate the problem. Enabled Activate automatically when the system boots up causing a warning message to appear when anything attempts to access the boot sector or hard disk partition table No warning message to appear when anything attempts to access the boot sector or hard disk partition table (Default Value) Disabled · Processor Number Feature Enabled Disabled Enable Processor number feature. (Default Value) Disable Processor number feature. 36 6VM7A+ Motherboard · Boot From LAN First Enabled Disabled Auto Enable Boot From LAN First. (Default Value) Auto detect Boot From LAN First. You can set "Auto" or "Enabled" to boot from LAN first. · Boot Sequence This category determines which drive computer searches first for the disk operating system (i. e. , DOS). X1, X2, X3 System will first search for X1 disk drive then X2 disk drive and then X3 disk drive. · VGA Boot From PCI Slot AGP System will boot from PCI slot VGA card. (Default Value) · Boot Up Floppy Seek During POST, BIOS will determine the floppy disk drive installed is 40 or 80 tracks. 360 K type is 40 tracks 720 K, 1. 2 M and 1. 44 M are all 80 tracks. Enabled BIOS searches for floppy disk drive to determine it is 40 or 80 tracks. Note that BIOS can not tell from 720 K, 1. 2 M or 1. 44 M drive type as they are all 80 tracks. (Default Value) BIOS will not search for the type of floppy disk drive by track number. Note that there will not be any warning message if the drive installed is 360 K. Disabled · Boot Up NumLock Status On Off Keypad is number keys. (Default Value) Keypad is arrow keys. · Memory Parity/ECC Check Enabled Disabled Enabled Memory Parity/ECC Check Function. Disabled Memory Parity/ECC Check Function. (Default Value) 37 BIOS Setup · Typematic Rate Setting Enabled Disabled Enable Keyboard Typematic rate setting. Disable Keyboard Typematic rate setting. (Default Value) · Typematic Rate (Chars / Sec. ) 6-30 Set the maximum Typematic rate from 6 chars. (Default Value: 6 ) · Typematic Delay (Msec. ) 250-1000 Set the time delay from first key to repeat the same key in to computer (Default Value: 250). · Security Option This category allows you to limit access to the system and Setup, or just to Setup. System Setup The system can not boot and can not access to Setup page will be denied if the correct password is not entered at the prompt. The system will boot, but access to Setup will be denied if the correct password is not entered at the prompt. (Default Value) · PCI/VGA Palette Snoop Enabled Disabled For having Video Card on ISA Bus and VGA Card on PCI Bus. (Default Value) · Assign IRQ For VGA Enabled Disabled Assign IRQ For VGA. [. . . ] The password typed now will clear the previously entered password from CMOS memory. You will be asked to confirm the password. Type the password again and press <Enter>. You may also press <Esc> to abort the selection and not enter a password. [. . . ]