User manual GIGABYTE GA-6VX7-4X

[. . . ] FCC Compliance Statement: This equipment has been tested and found to comply with limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] DOS uses this area to load device drivers to keep as much base memory free for application programs. Most use for this area is Shadow RAM 50 6VX7-4X Motherboard BIOS Features Setup AMIBIOS SETUP ­ BIOS FEATURES CMOS SETUP ( C ) 1999 American Megatrends, Inc. All Rights Reserved 1st Boot Device 2nd Boot Device 3rd Boot Device S. M. A. R. T for Hard Disks BootUp Num-Lock Floppy Drive Seek Password Check Process Serial Number :Floppy :IDE-0 :CDROM :Disabled :On :Disabled :Setup :Disabled ESC : Quit : Select Item F1 : Help PU/PD/+/- : Modify F5 : Old Values (Shift)F2 :Color F6 : Load BIOS Defaults F7 : Load Setup Defaults Figure 3: BIOS Features Setup · 1st / 2nd / 3rd Boot Device Floppy LS-120 / ZIP A: CDROM SCSI NETWORK IDE-0~IDE-3 Disabled ATAPI ZIP C: Boot Device by Floppy. Boot Device by ATAPI ZIP C:. · S. M. A. R. T. for Hard Disks Enabled Disabled Enabled S. M. A. R. T. (Default Value) 51 BIOS Setup · Boot Up Num-Lock On Off Keypad is number keys. (Default Value) Keypad is arrow keys. · Floppy Drive Seek During POST, BIOS will determine if the floppy disk drive installed is 40 or 80 tracks. 360 type is 40 tracks while 720 , 1. 2 and 1. 44 are all 80 tracks. Enabled BIOS searches for floppy disk drive to determine if it is 40 or 80 tracks. Note that BIOS can not tell from 720, 1. 2 or 1. 44 drive type as they are all 80 tracks. BIOS will not search for the type of floppy disk drive by track number. Note that there will not be any warning message if the drive installed is 360. (Default Value) Disabled · Password Check Setup Always Set Password Check to Setup. (Default Value) Set Password Check to Always. · Processor Serial Number Disabled Enabled Disabled Processor Serial Number. (Default Value) Enabled Processor Serial Number. 52 6VX7-4X Motherboard AMIBIOS SETUP ­CHIPSET FEATURE CMOS SETUP ( C ) 1999 American Megatrends, Inc. All Rights Reserved *** DRAM Timing *** Top Performance SDRAM Timing by SPD SDRAM CAS# Latency DRAM Frequency C2P Concurrency & Master DRAM Integrity Mode AGP Mode AGP Comp. Driving AGP Aperture Size USB Controller USB Legacy Support :Disabled :Disabled :3 :Auto :Enabled :Disabled :4X :Auto :CB :64MB :All USB Port :Disabled ESC : Quit : Select Item F1 : Help PU/PD/+/- : Modify F5 : Old Values (Shift)F2 :Color F6 : Load BIOS Defaults F7 : Load Setup Defaults Chipset Features Setup Figure 4: Chipset Features Setup · Top Performance If you wish to maximize the performance of your system, set "Top Performance" as "Enabled". Disabled Enabled Disabled this function. (Default Value) Enabled Top Performance function. · SDRAM Timing by SPD Disabled Enabled SDRAM Timing by SPD Function Disabled. (Default Value) SDRAM Timing by SPD Function Enabled. · SDRAM CAS# Latency 3 2 For Slower SDRAM DIMM module. (Default Value) For Fastest SDRAM DIMM module. · DRAM Frequency Auto Set DRAM Frequency to Auto. (Default Value) 53 BIOS Setup 66MHz 100MHz 133MHz Set DRAM Frequency is 66MHz. [. . . ] If the hard disk cylinder number is over 1024, then the user can select LBA mode or LARGER mode for DOS partition larger than 528 MB. 71 BIOS Setup Save & Exit Setup AMIBIOS SIMPLE SETUP UTILITY-VERSION 1. 20c ( C ) 1999 American Megatrends, Inc. All Rights Reserved STANDARD CMOS SETUP BIOS FEATURES SETUP CHIPSET FEATURES SETUP POWER MANAGEMENT SETUP INTEGRATED PERIPHERALS HARDWARE MONITOR SETUP SUPERVISOR PASSWORD USER PASSWORD SAVE to CMOS and EXIT(Y/N)?DETECTION PNP/PCI CONFIGURATION IDE HDD AUTO Y LOAD BIOS DEFAULTS LOAD SETUP DEFAULTS SAVE & EXIT SETUP EXIT WITHOUT SAVING ESC : Quit : Select Item (Shift) F2 : Change Color F5 : Old Values F6 : Load BIOS Defaults F7: Load Setup Defaults F10: Save & Exit Save Data to CMOS & Exit Setup Figure 13: Save & Exit Setup Type "Y" will quit the Setup Utility and save the user setup value to RTC CMOS. Type "N" will return to Setup Utility. 72 6VX7-4X Motherboard Exit Without Saving AMIBIOS SIMPLE SETUP UTILITY-VERSION 1. 20c ( C ) 1999 American Megatrends, Inc. [. . . ]