User manual GIGABYTE GA-6WOZ7

[. . . ] FCC Compliance Statement: This equipment has been tested and found to comply with limits for a Class B digital device , pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Note that there will not be any warning message if the drive installed is 360 K. Disabled · Boot Up NumLock Status On Off Keypad is number keys. ( Default value ) Keypad is arrow keys. · Gate A20 Option Normal Fast Set Gate A20 Option is Normal. ( Default value ) · Typematic Rate Setting Enabled Disabled Enable Keyboard Typematic rate setting. Disable Keyboard Typematic rate setting. ( Default value ) · Typematic Rate (Chars / Sec. ) 6-30 Set the maximum Typematic rate from 6 chars. ( Default value:6 ) · Typematic Delay (Msec. ) 250-1000 Set the time delay from first key to repeat the same key in to computer. ( Default value:250 ) · Security Option This category allows you to limit access to the system and Setup, or just to Setup. System Setup The system can not boot and can not access to Setup page will be denied if the correct password is not entered at the prompt. The system will boot, but access to Setup will be denied if the correct password is not entered at the prompt. ( Default value ) 44 6WOZ7 Motherboard · OS Select For DRAM>64MB Non-OS2 OS2 Using non-OS2 operating system. ( Default value ) Using OS2 operating system and DRAM>64MB. · HDD S. M. A. R. T. Capability Enabled Disabled Enabled HDD S. M. A. R. T. ( Default value ) · Report No FDD For WIN 95 No Yes Assign IRQ6 For FDD. ( Default value ) FDD Detect IRQ6 Automatically. 45 BIOS Setup Advanced Chipset Features CMOS Setup Utility -Copyright( C ) 1984-1999 Award Software Advanced Chipset Features SDRAM CAS Latency Time Auto Item Help SDRAM Cycle Time Tras/Trc 5/7 SDRAM RAS-to-CAS Delay 2 Menu Level 4 SDRAM RAS Precharge Time 2 DRAM Page Closing Policy Precharge Bank System BIOS Cacheable Enabled Video BIOS Cacheable Enabled Delayed Transaction Disabled On-Chip Video Window Size 64MB * Onboard Display Cache Setting * Initial Display Cache Display Cache Timing SDRAM Buffer Strength Enabled Fast Auto :Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help F5:Previous Values F6:Fail- Safe Defaults F7:Optimized Defaults Figure 5: Advanced Chipset Features · SDRAM CAS latency Time Auto 3 2 Set SDRAM CAS Latency Time to Auto. ( Default value ) For 67 / 83 MHz SDRAM DIMM module. For 100 MHz SDRAM DIMM module. · SDRAM Cycle Time Tras/Trc 6/8 5/7 Set DRAM Tras/Trc Cycle time is 6/8 SCLKs. Set DRAM Tras/Trc Cycle time is 5/7 SCLKs. ( Default value ) · SDRAM RAS -to-CAS delay 3 2 Set SDRAM RAS-to-CAS delay 3 SCLKs. ( Default value ) 46 6WOZ7 Motherboard · SDRAM RAS Precharge 3 2 Set SDRAM RAS Precharge is 3. ( Default value ) · DRAM Page Closing Policy Precharge Bank Precharge All Closing Policy Precharge Bank. ( Default value ) Closing Policy Precharge All. · System BIOS Cacheable Enabled Disabled Enable System BIOS Cacheable. ( Default value ) Disable System BIOS Cacheable. · Video BIOS Cacheable Enabled Disabled Enable video BIOS Cacheable. [. . . ] Type the password again and press <Enter>. You may also press <Esc> to abort the selection and not enter a password. To disable password, just press <Enter> when you are prompted to enter password. A message "PASSWORD DISABLED" will appear to confirm the password being disabled. [. . . ]