User manual GIGABYTE GA-6WXM

[. . . ] System power on by PS/2 Mouse: First, enable this function in CMOS Setup, then you can power on the system by double clicking the right or left button of your PS/2 Mouse. System power on by Keyboard: If your ATX power supply supports larger than 300 mA 5V Stand-By current (depends on the specification of keyboards), you can power on your system by entering password from the Keyboard after setting the "Keyboard power on" jumper and password in CMOS Setup. Support Modem Ring-On (Include internal Modem and external modem on COM A and COM B). Support Wake-up On LAN (Your ATX power supply must support larger than 720 mA 5V Stand-By current). 2. 3. [. . . ] The CPU Frequency is control by BIOS. JP6 / JP28: System Bus Speed AC97 JP6 1 YMF 744 JP28 1 IT8888 GMCH-E/ 82810E CPU AUTO 66 100 133 ICH/ JP682801 JP28 1-2 1-2 2-3 2-3 NC 2-3 NC Backup Main NC BIOS BIOS 6WXM «Note: Please set the CPU host frequency in accordance with your processor' s specifications. We don' t recommend you to set the system bus frequency over the CPU' s specification because these specific bus frequencies are not the standard specifications for CPU, chipset and most of the peripherals. Whether your system can run under these specific bus frequencies properly will depend on your hardware configurations, including CPU, Chipsets, SDRAM, Cards. . . CMOS RTC & ISA CFG CMOS RAM There're RTC & CMOS RAM on board; they have a power supply from external battery to keep the DATA inviolate & effective. The RTC is a REALTIME CLOCK device, which provides the DATE & TIME to system. The CMOS RAM is used for keeping the information of system configuration, so the system can automatically boot OS every time. Since the lifetime of 3-8 6WXM internal battery is 5 years, the user can change a new Battery to replace old one after it cannot work. M Danger of explosion if battery is incorrectly replaced. M Replace only with the same or equivalent type recommended by the manufacturer. M Dispose of used batteries according to the manufacturer' s instructions. 3. 7. SPEAKER CONNECTOR INSTALLATION There is a speaker in AT system for sound purpose. The 4 - Pins connector SPKR is used to connect speaker. 3. 8. HARDWARE RESET SWITCH CONNECTOR INSTALLATION The RESET switch on panel provides users with HARDWARE RESET function. The system will do a cold start after the RESET switch is pushed and released by user. The RESET switch is a 2 PIN connector and should be installed to RST on main board. 3. 9. POWER LED CONNECTOR INSTALLATION System has power LED lamp on the panel of chassis. The power LED will light on off or flash to indicate which step on the system. The connector should be connected to P+P-P- of main board in a correct direction. 3. 10. IDE & ATAPI DEVICE INSTALLATION There are two-Enhanced PCI IDE ports (IDE1, IDE2) on board, following ATAPI standard SPEC. Each IDE port can connected to two devices (IDE Hard Disk, CD-ROM or Tape Driver), so total four devices can exist in a system. The HD is the active LED port for devices. PERIPHERAL DEVICE INSTALLATION After the I/O device installation and jumpers setup, the main board can be mounted into the chassis and fixed by screw. [. . . ] You may also press <Esc> to abort the selection and not enter a password. To disable password, just press <Enter> when you are prompted to enter password. A message "PASSWORD DISABLED" will appear to confirm the password being disabled. Once the password is disabled, the system will boot and you can enter Setup freely. [. . . ]