User manual GIGABYTE GA-78LMT-S2PV

[. . . ] GA-78LMT-S2PV User's Manual Rev. 5001 12ME-78LTS2V-5001R Motherboard GA-78LMT-S2PV Motherboard GA-78LMT-S2PV Oct. 14, 2013 Copyright © 2013 GIGA-BYTE TECHNOLOGY CO. , LTD. The trademarks mentioned in this manual are legally registered to their respective owners. Disclaimer Information in this manual is protected by copyright laws and is the property of GIGABYTE. [. . . ] Options are: X4. 00, X5. 33, X6. 66, X8. 00. && HT Link Frequency && Set Memory Clock && Memory Clock (Note) This item is present only when you install a CPU that supports this feature. - 19 - `` DRAM Configuration && DCTs Mode && DDR3 Timing Items Allows you to set memory control mode. Ganged  Sets memory control mode to single dual-channel. Unganged  Sets memory control mode to two single-channel. (Default) Manual allows all DRAM timing control items below to be configurable. Options are: Auto (default), 90ns, 110ns, 160ns, 300ns, 350ns. Options are: Auto (default), 90ns, 110ns, 160ns, 300ns, 350ns. Options are: Auto (default), 5T~8T, 10T, 12T. Options are: Auto (default), 4T~7T. && 1T/2T Command Timing && CAS# latency && RAS to CAS R/W Delay && Row Precharge Time && Minimum RAS Active Time && TwTr Command Delay && Trfc0 for DIMM1, DIMM3 && Trfc1 for DIMM2, DIMM4 && Write Recovery Time && Precharge Time && Row Cycle Time && RAS to RAS Delay && Channel Interleaving && Rank Interleaving Enables or disables memory channel interleaving. Enabled allows the system to simultaneously access different channels of the memory to increase memory performance and stability. (Default: Enabled) Enables or disables memory rank interleaving. Enabled allows the system to simultaneously access different ranks of the memory to increase memory performance and stability. (Default: Enabled) Enables or disables memory DQS training each time the system restarts. (Default: Skip DQS) Determines whether to enable memory clock tri-stating in CPU C3 or Alt VID mode. (Default: Disabled) && DQS Training Control && Memclock tri-stating - 20 - ******** System Voltage Optimized ******** && System Voltage Control && NorthBridge Volt Control Determines whether to manually set the system voltages. Auto lets the BIOS automatically set the system voltages as required. Manual allows all voltage control items below to be configurable. (Default: Auto) Allows you to set the North Bridge voltage. Normal  Supplies the North Bridge voltage as required. (Default) +0. 1V ~ +0. 3V  The adjustable range is from 0. 1V to 0. 3V. Normal  Supplies the memory voltage as required. (Default) 1. 500V ~ 1. 900V The adjustable range is from 1. 500V to 1. 900V. [. . . ] Installing Windows XP Restart your system to boot from the Windows XP setup disk and press <F6> as soon as you see the message "Press F6 if you need to install a 3rd party SCSI or RAID driver. " Insert the floppy disk containing the SATA RAID/AHCI driver. Follow the on-screen instructions to install the driver that suits your operating system. When completed, proceed with the Windows XP installation. B. Installing Windows 7 Restart your system to boot from the Windows 7 setup disk and perform standard OS installation steps. [. . . ]