User manual GIGABYTE GA-990FXA-UD5 R5

[. . . ] GA-990FXA-UD5 R5 User's Manual Rev. 1001 12ME-990FXR5-1001R Motherboard GA-990FXA-UD5 R5 Motherboard GA-990FXA-UD5 R5 Feb. 1, 2015 Copyright © 2015 GIGA-BYTE TECHNOLOGY CO. , LTD. The trademarks mentioned in this manual are legally registered to their respective owners. Disclaimer Information in this manual is protected by copyright laws and is the property of GIGABYTE. [. . . ] AHCI  C  onfigures the SATA controllers to AHCI mode. Advanced Host Controller Interface (AHCI) is an interface specification that allows the storage driver to enable advanced Serial ATA features such as Native Command Queuing and hot plug. (Default) This option is configurable only when OnChip SATA Type is set to RAID or AHCI. Configures the operating mode of the integrated SATA3 4~SATA3 5 connectors. As SATA Type The mode depends on the OnChip SATA Type settings.  IDE  D  isables RAID for the SATA controller and configures the SATA controller to IDE mode. (Default) && OnChip SATA Port4/5 Type (SATA3 4~SATA3 5 connectors) - 49 - BIOS Setup && HD Audio Azalia Device Enables or disables the onboard audio function. (Default: Enabled) If you wish to install a 3rd party add-in audio card instead of using the onboard audio, set this item to Disabled. Enables or disables the integrated USB controller. (Default: Enabled) && Onboard USB Device && Onboard LAN Controller Enables or disables the onboard LAN function. (Default: Enabled) If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to Disabled. Enables or disables the SATA controller integrated in the Marvell® 88SE9172 chip. (Default: Enabled) Enables or disables the VIA® VL805 USB controller. (Default: Enabled) Enables or disables the SATA controller integrated in the Marvell® 88SE9172 chip. (Default: Enabled) Allows USB keyboard/mouse to be used in MS-DOS. (Default: Enabled) && Onboard GSATA Controller (Marvell® 88SE9172 chip, GSATA3 6 and GSATA3 7 connectors) && Onboard USB3. 0 Controller (VIA® VL805 USB Controller) && Onboard eSATA Controller (Marvell® 88SE9172 chip, eSATA connectors on the back panel) && Legacy USB Support && XHCI Hand-off Determines whether to enable XHCI Hand-off feature for an operating system without XHCI Hand-off support. (Default: Enabled) Determines whether to enable EHCI Hand-off feature for an operating system without EHCI Hand-off support. (Default: Disabled) Enables or disables emulation of I/O ports 64h and 60h. This should be enabled for full legacy support for USB keyboards/mice in MS-DOS or in operating system that does not natively support USB devices. (Default: Disabled) Displays a list of connected USB mass storage devices. This item appears only when a USB storage device is installed. (Default: Enabled) && EHCI Hand-off && Port 60/64 Emulation && USB Storage Devices && IOMMU Controller `` Trusted Computing && TPM SUPPORT Enables or disables Trusted Platform Module (TPM). [. . . ] With your help, we can reduce the amount of natural resources needed to produce electrical and electronic equipment, minimize the use of landfills for the disposal of "end of life" products, and generally improve our quality of life by ensuring that potentially hazardous substances are not released into the environment and are disposed of properly. - 97 - Appendix FCC Notice (U. S. A. Only) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ]