User manual GIGABYTE GA-E350N-USB3

[. . . ] GA-E350N-USB3 FT1 BGA motherboard Built in with an AMD E-350 Dual-Core processor User's Manual Rev. 1001 12ME-E350NB3-1001R Motherboard GA-E350N-USB3 Motherboard GA-E350N-USB3 Dec. 17, 2010 Copyright © 2011 GIGA-BYTE TECHNOLOGY CO. , LTD. The trademarks mentioned in this manual are legally registered to their respective owners. Disclaimer Information in this manual is protected by copyright laws and is the property of GIGABYTE. [. . . ] (Default) System A password is required for booting the system and for entering the BIOS Setup program. (Self Monitoring and Reporting Technology) capability of your hard drive. This feature allows your system to report read/write errors of the hard drive and to issue warnings when a third party hardware monitor utility is installed. (Default: Enabled) - 37 BIOS Setup Password Check HDD S. M. A. R. T. Capability Away Mode Enables or disables Away Mode in Windows XP Media Center operating system. Away Mode allows the system to silently perform unattended tasks while in a low-power mode that appears off. (Default: Disabled) AllowsthesystemtocopytheBIOSimagefiletotheharddrive. IfthesystemBIOSiscorrupted, itwill berecoveredfromthisimagefile. (Default:Disabled) Specifies the first initiation of the monitor display from the PCI Express graphics card or the onboard graphics. Onboard Setstheonboardgraphicsasthefirstdisplay. PEG SetsthePCIExpressgraphicscardasthefirstdisplay. (Default) Backup BIOS Image to HDD Init Display First BIOS Setup - 38 - 2-6 x Integrated Peripherals CMOS Setup Utility-Copyright (C) 1984-2010 Award Software Integrated Peripherals OnChipSATAController OnChipSATAType OnChipSATA3. 0Support OnChip SATA Port as ESP OnboardLANFunction OnboardLANBootROM SMARTLAN OnboardAudioFunction OnboardUSB3. 0Controller USBControllers USBLegacyFunction USBStorageFunction [Enabled] [NativeIDE] [Enabled] Press Enter [Enabled] [Disabled] [PressEnter] [Enabled] [Enabled] [Enabled] [Enabled] [Enabled] Item Help Menu Level Enter: Select higf: Move F5: Previous Values +/-/PU/PD: Value F6: Fail-Safe Defaults F10: Save ESC: Exit F1: General Help F7: Optimized Defaults OnChip SATA Controller OnChip SATA Type Enables or disables the integrated SATA controller. (Default: Enabled) ConfigurestheoperatingmodeoftheintegratedSATAcontroller. Native IDE Allows the SATA controller to operate in Native IDE mode. (Default) Enable Native IDE mode if you wish to install operating systems that support Native mode. AHCI ConfigurestheSATAcontrollerstoAHCImode. AdvancedHostControllerInterface (AHCI)isaninterfacespecificationthatallowsthestoragedrivertoenableadvanced Serial ATA features such as Native Command Queuing and hot plug. OnChip SATA3. 0 Support Enables or disables the SATA 6Gb/s function integrated in the FCH. When set to Disabled, the SATA controller will operate in SATA 3Gb/s mode. (Default: Enabled) OnChip SATA Port as ESP CMOS Setup Utility-Copyright (C) 1984-2010 Award Software OnChip SATA Port as ESP Port0asESP Port1asESP Port2asESP Port3asESP [Disabled] [Disabled] [Disabled] [Disabled] Item Help Menu Level Enter: Select higf: Move F5: Previous Values +/-/PU/PD: Value F6: Fail-Safe Defaults F10: Save ESC: Exit F1: General Help F7: Optimized Defaults Port0 as ESP/ Port1 as ESP/ Port2 as ESP/ Port3 as ESP ThisoptionisconfigurableonlywhenOnChip SATA Type is set to AHCI. Enabled will speed up the hot plug detection of the connected SATA device. (Default: Disabled) - 39 BIOS Setup Onboard LAN Function Enables or disables the onboard LAN function. (Default: Enabled) If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to Disabled. Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip. (Default: Disabled) Onboard LAN Boot ROM SMART LAN (LAN Cable Diagnostic Function) CMOS Setup Utility-Copyright (C) 1984-2010 Award Software SMART LAN Start detecting at Port. . . . . Part1-2 Status = Open Part3-6 Status = Open Part4-5 Status = Open Part7-8 Status = Open / / / / Length Length Length Length = = = = 0m 0m 0m 0m Item Help Menu Level Enter: Select higf: Move F5: Previous Values +/-/PU/PD: Value F6: Fail-Safe Defaults F10: Save ESC: Exit F1: General Help F7: Optimized Defaults This motherboard incorporates cable diagnostic feature designed to detect the status of the attached LAN cable. This feature will detect cabling issue and report the approximate distance to the fault or short. [. . . ] Connect the ATX main power cable and the 12V power cable. Turn on the power to start the computer. Theproblemisverifiedandsolved. Make sure the graphics card is securely seated in the expansionslotandpowerconnectorsarefirmlyattached. A (Continued. . . ) - 73 - Appendix A When the computer is turned on, is the CPU cooler running?Yes No The power supply, CPU or CPU socket might fail. Theproblemisverifiedandsolved. No The graphics card, expansion slot, or monitor might fail. Check if there is display on your monitor. [. . . ]