User manual GIGABYTE GA-F2A75M-HD2

[. . . ] GA-F2A75M-HD2 User's Manual Rev. 100 12ME-F275HD2-100 R Motherboard GA-F2A75M-HD2 Motherboard GA-F2A75M-HD2 Sept. 14, 2012 Copyright © 2012 GIGA-BYTE TECHNOLOGY CO. , LTD. The trademarks mentioned in this manual are legally registered to their respective owners. Disclaimer Information in this manual is protected by copyright laws and is the property of GIGABYTE. [. . . ] (Default) Profile1  Uses Profile 1 settings. Profile2 (Note) Uses Profile 2 settings.  Allows you to set the system memory multiplier. Auto sets memory multiplier according to memory SPD data. (Default: Auto) This value is automatically adjusted according to the BCLK/PCIe Clock Control and System Memory Multiplier settings. && Memory Frequency (MHz) `` Advanced Memory Settings && Extreme Memory Profile (X. M. P. ) (Note), System Memory Multiplier, Memory Frequency(Mhz) && DRAM Timing Selectable The settings above are synchronous to those under the same items on the Advanced Frequency Settings menu. Quick and Expert allows the memory timing settings below to be configurable. Options are: Auto (default), Quick, Expert. When using a non-XMP memory module or Extreme Memory Profile (X. M. P. ) is set to Disabled, this item will display as 1. 50V. When Extreme Memory Profile (X. M. P. ) is set to Profile1 or Profile2, this item will display the value based on the SPD data on the XMP memory. The value displayed here is dependent on the CPU being used. && Profile DDR Voltage && Profile VTT Voltage && Rank Interleaving Enables or disables memory rank interleaving. Enabled allows the system to simultaneously access different ranks of the memory to increase memory performance and stability. (Default: Enabled) This item is present only when you install a memory module that supports this feature. - 30 - (Note) && Channel Interleaving Enables or disables memory channel interleaving. Enabled allows the system to simultaneously access different channels of the memory to increase memory performance and stability. (Default: Enabled) Channel A/B Timing Settings `` This sub-menu provides memory timing settings for each channel of memory. The respective timing setting screens are configurable only when DRAM Timing Selectable is set to Quick or Expert. Note: Your system may become unstable or fail to boot after you make changes on the memory timings. If this occurs, please reset the board to default values by loading optimized defaults or clearing the CMOS values. `` Advanced Voltage Settings This sub-menu allows you to set CPU, Chipset, and memory voltages. - 31 - `` PC Health Status && Reset Case Open Status Disabled Keeps or clears the record of previous chassis intrusion status. (Default)  Enabled   Clears the record of previous chassis intrusion status and the Case Open field will show "No" at next boot. Displays the detection status of the chassis intrusion detection device attached to the motherboard CI header. If the system chassis cover is removed, this field will show "Yes", otherwise it will show "No". [. . . ] Follow the on-screen instructions to install the driver that suits your operating system. When completed, proceed with the Windows XP installation. (The following instructions use Windows 7 as the example operating system. ) Boot from the Windows 7 setup disk and perform standard OS installation steps. When the screen requesting you to load the driver appears, select Browse. Then browse to the USB flash drive that contains the driver and select the location of the driver. [. . . ]