User manual GIGABYTE GA-Z97MX-GAMING 5

[. . . ] GA-Z97MX-Gaming 5 User's Manual Rev. 1001 12ME-Z97MGM5-1001R Motherboard GA-Z97MX-Gaming 5 Motherboard GA-Z97MX-Gaming 5 Apr. 3, 2014 Copyright © 2014 GIGA-BYTE TECHNOLOGY CO. , LTD. The trademarks mentioned in this manual are legally registered to their respective owners. Disclaimer Information in this manual is protected by copyright laws and is the property of GIGABYTE. [. . . ] Press <Enter> on this item, type the password, and then press <Enter>. You will be requested to confirm the password. Type the password again and press <Enter>. You must enter the administrator password (or user password) at system startup and when entering BIOS Setup. Differing from the user password, the administrator password allows you to make changes to all BIOS settings. Allows you to configure a user password. Press <Enter> on this item, type the password, and then press <Enter>. You will be requested to confirm the password. Type the password again and press <Enter>. You must enter the administrator password (or user password) at system startup and when entering BIOS Setup. However, the user password only allows you to make changes to certain BIOS settings but not all. To cancel the password, press <Enter> on the password item and when requested for the password, enter the correct one first. When prompted for a new password, press <Enter> without entering any password. Press <Enter> again when prompted to confirm. BIOS Setup - 54 - 2-6 Peripherals && Initial Display Output && XHCI Mode Specifies the first initiation of the monitor display from the installed PCI Express graphics card or the onboard graphics. IGFX  Sets the onboard graphics as the first display. PCIe 1 Slot  Sets the graphics card on the PCIEX16 slot as the first display. (Default) PCIe 2 Slot  Sets the graphics card on the PCIEX8 slot as the first display. PCIe 3 Slot  Sets the graphics card on the PCIEX4 slot as the first display. Allows you to determine the operating mode for the xHCI controller in OS. Smart Auto This mode is available only when the BIOS supports the xHCI controller in the pre-boot  environment. This mode is similar to Auto, but it adds the capability to route the ports to xHCI or EHCI according to setting used in previous boots (for non-G3 boot) in the pre-boot environment. This allows the use of USB 3. 0 devices prior to OS boot. [. . . ] With your help, we can reduce the amount of natural resources needed to produce electrical and electronic equipment, minimize the use of landfills for the disposal of "end of life" products, and generally improve our quality of life by ensuring that potentially hazardous substances are not released into the environment and are disposed of properly. Appendix - 112 - FCC Notice (U. S. A. Only) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ]