User manual GIGABYTE MA9CU

[. . . ] To notify any person of such revision or changes. E1 G-MAX TM Micro ATX Series User's Manual Preface This system unit is designed to be stable, safe, and easy to use. The system can be upgraded and expanded in function easily if correct procedure is followed. For your own safety and to avoid accidental damage to your system, please ensure you follow the following precautions: Follow all the warnings and instructions marked on the products. [. . . ] Hence, the system can be shut down automatically under Microsoft Windows 98 (or higher versions) commands. Note: Please check the voltage requirements in the country you reside before turning on the PC. System Component Installation Remove the screws of the side cover of the chassis, push backward to dismount the cover. Remove front panel For different processor types, please refer to below installation guide. CPU (For Intel Pentium CPU Pin Lever and Intel Celeron processors) P. E4 G-MAX TM Micro ATX Series User's Manual 1. Before installation, lift up the lever and align the cut of the CPU with the marking on the socket. Pull down the lever to lock the CPU on the socket after installation. When you are installing the heat sink, please make sure to keep the heat sink tight against the CPU to obtain the best cooling result. Apply the thermal compound to one side of the template, and ensure the compound is spread evenly across the template and repeat if necessary. Connect fan power connector to the CPU FAN connector on the motherboard. Click heat sink lock on the CPU socket Install fan on top of CPU CPU(For Intel Pentium 4 processors) CPU Pin Lever 1. Insert the CPU on the CPU socket. Before installation, lift up the lever and align the cut of the CPU with the marking on the socket. 2. Pull down the lever to lock the CPU on the socket after installation. Put CPU cooler on retention module and make sure to keep the heat sink tight against the CPU to obtain the best cooling result. Apply the thermal compound to one side of the template, and ensure the compound is spread evenly across the template and repeat if necessary. Connect fan power connector to the CPU FAN connector on the motherboard. Click the heat sink locker to the motherboard retention module. E5 G-MAX CPU (For Intel Tualatin processors) TM Micro ATX Series User's Manual In this section you will find the gist of CPU installation. CPU Pin Lever 1. Insert the CPU on the CPU socket. Before installation, lift up the lever and align the cut of the CPU with the marking on the socket. 2. Pull down the lever to lock the CPU on the socket after installation. Put CPU cooler on retention module and make sure to keep the heat sink tight against the CPU to obtain the best cooling result. [. . . ] If you use microphone for recording, please insert it in the Front Audio Port. MIC IN LINE OUT TM USB Port G-MAX Micro ATX Front Audio Port P. E10 G-MAX Rear Panel TM Micro ATX Series User's Manual Power Socket Voltage Switch Keyboard Port(PS/2) USB Port COM Port *VGA / COM Port Audio Out Audio In MIC In *1394 Port Mouse Port(PS/2) *LAN Port LPT Port System Fan Game Port Power Socket Voltage Switch Keyboard Port (PS/2) COM Port *VGA / COM Port Audio Out Audio In MIC In USB Port LPT Port System Fan Game Port *LAN Port *1394 Port Mouse Port (PS/2) P. E11 G-MAX Note TM Micro ATX Series User's Manual 1. To avoid broken disc during high-speed operation, we recommend you to use high quality CD/ Recordable CD/ Re-writable CD. 2. Specification with " " mark are subject to change without notice. [. . . ]