User manual GIGABYTE MIB T3140

[. . . ] If this Eric Lu equipment does cause interference to radio or television equipment reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: DECLARATION OF CONFORMITY Per FCC Part 2 Section 2. Address: 18305 Valley Blvd. , Suite#A LA Puent, CA 91744 Phone/Fax No: (818) 854-9338/ (818) 854-9339 hereby declares that the product Product Name: Mother Board Model Number: MIB T3140 Conforms to the following specifications: FCC Part 15, Subpart B, Section 15. 107(a) and Section 15. 109(a), Class B Digital Device Supplementary Information: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful and (2) this device must accept any inference received, including that may cause undesired operation. ERIC LU Representative Person's Name: Signature: Date: Jul. [. . . ] User type is user-definable; Auto type which will automatically detect HDD type. Note that the specifications of your drive must match with the drive table. The hard disk will not work properly if you enter improper information for this category. If you select User Type, related information will be asked to enter to the following items. Enter the information directly from the keyboard and press <Enter>. Such information should be provided in the documentation form your hard disk vendor or the system manufacturer. Number of cylinders HEADS number of heads PRECOMP write precomp LANDZONE Landing zone SECTORS number of sectors If a hard disk has not been installed select NONE and press <Enter>. · Floppy Drive A / Drive B The category identifies the types of floppy disk drive A or drive B that has been installed in the computer. No floppy drive installed 5. 25 inch PC-type standard drive; 360K byte capacity. 5. 25 inch AT-type high-density drive; 1. 2M byte capacity (3. 5 inch when 3 Mode is Enable). 3. 5 inch double-sided drive; 720K byte capacity 3. 5 inch double-sided drive; 1. 44M byte capacity. 3. 5 inch double-sided drive; 2. 88M byte capacity. 42 7ZXE Motherboard · Boot Sector Virus Protection If it is set to enable, the category will flash on the screen when there is any attempt to write to the boot sector or partition table of the hard disk drive. Driving AGP Aperture Size PCI Delay Transaction USB Controller USB Legacy Support USB Port 64/60 Emulation BIOS Flash Protection DRAM Drive Strength MD Bus Strength CAS Bus Strength Delay DRAM Read Latch Memory Data Drive Disabled 4X Auto DB 64MB Enabled All USB Port Disabled Disabled Auto Auto High High 1. 0ns 8 mA 24 mA 24 mA 12 mA 24 mA ESC: Quit : Select Item F1 : Help PU/PD+/-/ : Modify F5 :Old Values (Shift)F2:Color F6 : Load Fail-Safe F8: Flash Utility F7 : Load Optimized Figure 4: Chipset Features Setup · Top Performance If you wish to maximize the performance of your system, set "Top Performance" as "Enabled". Disabled Enabled Top Performance Disable. (Default Value) Top Performance Enable. · DRAM Frequency Auto 100MHz 133MHz Set DRAM Frequency to Auto. (Default Value) Set DRAM Frequency to 133MHz. · SDRAM CAS# Latency 2 3 Auto For Fastest SDRAM DIMM module. (Default Value) Detect SDRAM CAS# Latency by SPD. 46 7ZXE Motherboard · AGP Fast Write Enabled Disabled Enable this function only if the AGP Card support Fast Write Function. (Enable this function can increase AGP performance). (Default Value) · AGP Mode 4X 1X 2X Set AGP Mode to 4X. Set AGP Mode to 2X. · AGP Comp. Driving: 00~FF · AGP Aperture Size 4MB 8MB 16MB 32MB 64MB 128MB 256MB Set AGP Aperture Size to 4MB. (Default Value) Set AGP Aperture Size to 128 MB. Set AGP Aperture Size to 256 MB. · PCI Delay Transaction Enabled Disabled Enable Delay Transaction. [. . . ] Please search for BIOS unzip file, downloading from internet or any other methods (such as: 7ZXE. F1). Complete update process following the instruction. III. Save BIOS In the very beginning, there is "Save Current BIOS" icon shown in dialog box. It means to save the current BIOS version. [. . . ]