User manual GIGABYTE XA2CB

[. . . ] To notify any person of such revision or changes. E1 G-MAX TM ATX Series User's Manual Preface This system unit is designed to be stable, safe, and easy to use. The system can be upgraded and expanded in function easily if correct procedure is followed. For your own safety and to avoid accidental damage to your system, please ensure you follow the following precautions: Follow all the warnings and instructions marked on the products. [. . . ] Hence, the system can be shut down automatically. Note: Please check the voltage requirements in the country you reside before turning on the PC. System Component Installation Remove the screws of the back cover of the chassis, push backward to dismount the cover. Remove front panel P. E4 G-MAX CPU TM ATX Series User's Manual 1. Before installation, lift up the lever and align the cut of the CPU with the marking on the socket. Pull down the lever to lock the CPU on the socket after installation. When you are installing the heat sink, please make sure to keep the heat sink tight against the CPU to obtain the best cooling result. Apply the thermal compound to one side of the template, and ensure the compound is spread evenly across the template and repeat if necessary. Connect fan power connector to the CPU FAN connector on the motherboard. For Intel Pentium 4 processors CPU Pin Lever Apply thermal grease to the top of the CPU properly. Click the heat sink locker to the motherboard retention module. For AMD Athlon CPU Pin TM and AMD Duron TM processors Lever Apply thermal grease to the top of the CPU properly. P. E5 G-MAX TM ATX Series User's Manual Install fan on top of CPU Click the heat sink locker to the motherboard retention module. Set CPU clock frequency from BIOS Setup, see Motherboard Manual for details. Memory Notches at sides of module SDRAM Position notches. Make sure that the notches should align the pin on memory slot on the motherboard Notches at sides of module DDR Position notches. Make sure that the notches should align the pin on memory slot on the motherboard P. E6 G-MAX TM ATX Series User's Manual In this section we will guide you to install memory module. First, make sure the position notches at the bottom of the module should align to the pins on the module sockets on the motherboard, then push the module downward until the locks hook up notches at sides. Locks: make sure they hook up the notches at sides of module Hard Drive Installation 1. Remove 4 screws in front of the hard drive chassis and dismount chassis. HDD frame Press down splinter then pull out HDD frame. 2. The chassis accommodates up to six 3. 5" storage devices. Select a place and fix the hard drive with screws. 3. 5" floppy Drive HDD Drive HDD frame P. E7 G-MAX TM ATX Series User's Manual 3. Connect the IDE cable included in the accessory box to the connector on the hard drive. [. . . ] E14 G-MAX TM ATX Series User's Manual For those models with SPDIF only User's Guide for Digital CD audio 1. Insert the Driver CD that was included in accessory box into your CD-ROM. If the digital CD audio can't output normally after audio driver is updated, please operate step by step as below. (A) Click on Start Settings Control Panel (B) Select "System Properties" P. [. . . ]