User manual GIGAFAST EE101-AEX

[. . . ] PCMCIA Fast Ethernet card user's manual PCMCIA 10/100M Fast Ethernet Card User's Manual Rev 2. 0 PCMCIA Fast Ethernet card user's manual Regulatory compliance This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. This equipment also complies with CE EN55022 Class B and VCCI V3 Class B specifications. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. [. . . ] To check whether the network component has been installed, double click the Network icon in the Control Panel. If it has not been installed, refer to the Windows NT 4. 0 installation guide for instructions on installing the component. Follow the steps below to install the driver. Insert the Ethernet card into an available PCMCIA slot on your notebook. Log in to NT 4. 0 as "Administrator". Double click the Network icon in the Control Panel, and select the Adapters tab as shown in the following screen: 32 PCMCIA Fast Ethernet card user's manual 4. Type "E:\Driver\WinNT40" where "E" is your CD-ROM drive letter. After finding the installation file, the Select OEM Option window is displayed. 33 PCMCIA Fast Ethernet card user's manual 7. A screens appears prompting you to input the IRQ, I/O port address, and connection type: 8. Select the desired resources and connection type. Note! You must select resources that are not being used by another device; otherwise, you will have a system conflict error. In case of a system conflict error, try another setting and continue. 9. Windows will configure the Ethernet card. You are returned to the Network window. 34 PCMCIA Fast Ethernet card user's manual 10. Windows NT 4. 0 will bind the adapter with the network component and you will be prompted to restart the system. When Windows NT is finished binding the adapter to the network component, you are prompted to restart the system. Click Yes to finish the installation. 35 PCMCIA Fast Ethernet card user's manual Chapter 4 Driver installation for DOS environments This section covers Ethernet Card driver installation for DOS environment operating systems. System Requirements Hardware Requirements Software Requirements Notebook equipped with Type II PC Card slot and PC Card controller (compliant Rev. 2. 1 or higher The Card & Socket service drivers should comply with PCMCIA Release 2. 1 or higher Driver installation You must install the Ethernet Card drivers before your computer system can recognize your Ethernet Card. The following sections cover client driver installation. Driver installation program INSTALL is the Ethernet Card driver installation program. The INSTALL program automatically selects the most suitable option settings, or you can perform a custom configuration where you individually select each setting. 36 PCMCIA Fast Ethernet card user's manual Quick installation This section gives a brief overview of the installation process. Card and Socket Services software should be bundled with your computer; if it is not, contact your dealer. It is recommended that you use this software when installing your Ethernet Card. A system with Card and Socket Services installed allows the PCMCIA card to automatically configure itself. [. . . ] Solution: To prevent this phenomenon from occurring, stop the card by using the PC Card tool in the Control Panel or the PC Card icon on the taskbar before you remove the card. Problem: The card cannot be detected when reinserted. Cause: This is caused by certain unstable PCMCIA status lines when the card is removed and reinserted. The Windows 95/98 drivers may read an incorrect status during this period of signal instability, and fail to detect the correct status of the card. [. . . ]