User manual GIGAFAST EF800-SI

[. . . ] Introduction This manual describes the installation and the us a ge o f E F8 00 - S I . I t f e at u r es ei gh t 10 / 10 0 Base-TX auto-negotiation switch port with in t er n a l A C p o w er s u pp l y, a n d pr o v id e s t h e flexibility to into your working space and networking environment . [. . . ] For straight-through Category 5/5e twisted ­pair cable with RJ-45 plugs: 1. Connect one end of the cable to the switch EF-800SI's uplink port, while keeping port 1 unplugged. Be sure follow the length limit of 100 meter. Connect the other end of the cable to any available port, except the uplink one, of the other devices. Connect, respectively, any two available nonuplink pork of these 2 devices. Or, connect both uplink ports of these 2 devices together. Verify System Operation Check each connection by viewing the port status indicators shown in the following table. The switch EF800-SI monitors various statuses for every port. If there is any abnormal condition, please follow the trouble-shooting advice detailed in the next section. Troubleshooting by the Diagnostic LED Indicators LED Power State On Off On Off Flashing On Off On Off Indication EF800-SI is powered. Port has established a valid network connection. Port has not established a valid network connection Traffic is traversing the port. Port operates in full-duplex mode or collision in half-duplex mode. Port operates in half-duplex mode without collision. LNK/ACT 100Mbps FDX/COL The operation of EF800-SI can be easily monitored through panel LED indicators to assist the network manager in identif ying problems. [. . . ] It has been tested and found to comply with the limits for a Class A digital device pursuant to Subpart B of Part 15 FCC Rules, which are designed to provide reasonable protection against such interference when operated in a commercial environment operation of this equipment in a residential area is likely to cause interference, in which case the user, at t his own expense, will be requir ed to take whatever measure ar e required to correct the interference. CE Mark Declaration of Conformance This is to certify that this product complies with ISO/IEC Guide 22 and EN45014. It conforms to the following specifications: EMC: N55022(1988)/CISPR-22(1985) Class A IEC 1000-4-2(1995) IEC 1000-4-3(1995) IEC 1000-4-4(1995) Line IEC 1000-4-6(1995) 3Vrms 4Kv cd, 8Kv AD 3V/m 1Kv-Power Line 0. 5Kv-Signal This product complies with the requirements of the low Voltage Directive 73/23/EEC and the EMC directive 89/336/EEC. Warning Do not plug a phone jack connector into any of the RJ-45 port. [. . . ]