User manual GIGAFAST PE902-EBX

[. . . ] HomePlug Ethernet Bridge PE 902-EBx User Manual Copyright The contents of this publication may not be reproduced in any part of as a whole, stored, transcribed in an information retrieval system, translated into any language, or transmitted in any form or by any means, mechanical, magnetic, electronic, optical, photocopying, manual, or otherwise, without prior written permission. Trademarks All product, company, and brand names are trademarks or registered trademarks of their respective companies. They are used for identification purpose only. Specifications are subject to be charged without prior notice. FCC Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against radio interference in a commercial environment. [. . . ] (192. 168. XXX. XXX is very standard for home networks) Click on the Subnet mask, and if you know the subnet mask you want to use, type it in, otherwise it should fill in with "255. 255. 255. 0" which is very standard for subnet masks. 30 4. Click on the "Gateway" tab, and add in your gateway IP address. 31 5. Click on the "DNS Configuration" tab, and add in your DNS server IP address. Click OK button when you done. 32 5. To save the changes you must restart, so click "YES" 33 Part 2: Windows 2000 / XP 1. Right click My Network Places and click Properties. 34 2. Find and "Double Click" the Local Area Connection for the Network adapter you want to Set IP's for. 35 3. Click(Highlight) "Internet Protocol (TCP/IP)" and click "Properties" 37 5. Click "Use the following IP address" Type in the IP Address you wish to use. (192. 168. XXX. XXX is very standard for home networks) Click on the Subnet mask, and if you know the subnet mask you want to use, type it in, otherwise it should fill in with "255. 255. 255. 0" which is very standard for subnet masks. Click on the Default gateway and fill that in. If you know the DNS you are going to use, fill it in otherwise leave it blank. To check that everything is Correct, Click on "Support" and the information you typed in should appear. 39 Release and Renew an IP address Part 1: Windows 98 SE / ME 1. Type "winipcfg" and click OK 41 3. Select the Network adapter you want to release IP's for. 42 4. Your IP Address should turn to 0. 0. 0. 0 44 6. If you Click Release, and an error saying "IP Address for adapter is already released" then you do not need to release any more, Try "Renewing your IP" 45 Part 2: Windows 2000 / XP 1. Type "ipconfig /release" and press Enter 48 4. Your IP Address should turn to 0. 0. 0. 0 . To Renew your address check Renewing IP Address. 49 5. If you receive an Error "The operation failed as no adapter is in the state permissible for this operation. " Then you might need to set your Network adapter to obtain your "IP Address Automatically". 50 Appendix C: Local Area Network Sharing Files (Windows 98SE / ME / 2000 / XP) Part 1: Sharing Folders 1. Double click "My computer" on your O/S desktop 51 2. [. . . ] ("GFE") warrants its products to be free from defects in workmanship and materials, under normal use and service, for the applicable warranty term. All GFE products carry a standard limited warranty from the date of purchase from GFE or its Authorized Reseller. GFE may, at its own discretion, repair or replace any product not operating as warranted with a similar or functionally equivalent product, during the applicable warranty term. All products that are replaced become the property of GFE. [. . . ]