User manual GIGAFAST PE903-EB

[. . . ] GigaFast HomePlug Ethernet Bridge PE 903-EB User Manual Copyright The contents of this publication may not be reproduced in any part of as a whole, stored, transcribed in an information retrieval system, translated into any language, or transmitted in any form or by any means, mechanical, magnetic, electronic, optical, photocopying, manual, or otherwise, without prior written permission. Trademarks All product, company, and brand names are trademarks or registered trademarks of their respective companies. They are used for identification purpose only. Specifications are subject to be charged without prior notice. FCC Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against radio interference in a commercial environment. [. . . ] No, HomePlug operates in a different frequency band than other power line control devices and can co-exist with technologies as X-10, CEBus, and LONworks. Can my neighbor receive my HomePlug signal?It is possible for your neighbor receive your HomePlug signal between two adjacent homes. To prevent this happen, please enable the 56-bit DES security encryption on your HomePlug Device. To do that, you must run the HomePlug Connection Manager on each HomePlug device in your power line network. This will only allow computers with the same security password to be able to receive information. How do I find out what's my current speed of my HomePlug device?Run the HomePlug Connection Manager, it will show your current speed and your signal strength. How many HomePlug devices do I need to setup a powerline network?You must need two or more HomePlug devices to setup a powerline network. 31 Q. In order to making the HomePlug Ethernet Bridge working properly, do I have to install the HomePlug Connection Manager on every single computer who has the HomePlug Ethernet Bridge plug into it?No, the HomePlug Connection Manager is a utility to diagnose or setup encryption for HomePlug device. Due to HomePlug Ethernet Bridge is a fully plug & play device, no driver require to install. So technically speaking, the HomePlug Connection Manager is not a requirement to install on your computer. In other words, you can install the utility, setup the encryption, and delete it from your computer, but your HomePlug Ethernet Bridge will still working properly. How many HomePlug Ethernet Bridges that I can install into one same Local Area Network?But by the IP restriction, you might be able install up to 253 units in one same Local Area Network. Can I connect my HomePlug device to an extension cord or an UPS?Yes, HomePlug devices can be plugged onto extension cords, but please note that this will reduce the powerline signal strength of the connection. Please use a wall outlet if it's possible. HomePlug devices do not work with UPS at this time. Can I connect my HomePlug Ethernet Bridge to my Ethernet enabled PS2/Xbox/other device? [. . . ] ("GFE") warrants its products to be free from defects in workmanship and materials, under normal use and service, for the applicable warranty term. All GFE products carry a standard limited warranty from the date of purchase from GFE or its Authorized Reseller. GFE may, at its own discretion, repair or replace any product not operating as warranted with a similar or functionally equivalent product, during the applicable warranty term. All products that are replaced become the property of GFE. [. . . ]