User manual GLEM GHS98IX

[. . . ] The 4th speed (intensive) is automatically lowered to 3rd speed after 5 minutes of operation to optimise energy consumption. - If the hood is left on (lights and/or motor), after 10 hours in the absence of commands from the user, it will automatically switch to OFF condition with all services switched off. - In the event of interruption of power during the hood, if you restore the hood in the OFF state, then the engine must be reactivate manually. [. . . ] Decide from the outset which type is to be installed. For better efficiency, we recommend installing the hood in the ducting version (if possible). ducting version The hood purifies the air and evacuates it to the outside through an exhaust duct (diameter 150 mm). Filtering version The hood purifies the air and recycles the clean air back into the room. For this version you need to buy the filter kit. Filter alarm: After 30 hours of operation, with the motor off, the speed keys (keys B, C, D and E) are on for 30 seconds to indicate the grease filters need cleaning. After cleaning the grease filters, restart the hour counter (RESET) by pressing one of the keys (B, C, D and E) during filter alarm. After 120 hours of operation, with the motor off, the speed keys (keys B, C, D and E) flash for 30 seconds to indicate the grease filters need cleaning and the charcoal filters replaced. Restart the hour counter (RESET) by pressing one of the keys (B, C, D and E) during filter alarm. Timer 5'; the timer can be started (switch-off delayed by 5 minutes) by pressing the keys B, C, or D for 2 seconds when the motor is running; the selected speed key starts flashing. Before cleaning or maintenance cut the power. Cleaning the hood WHEN TO CLEAN IT: clean it at least every 2 months to prevent the risk of fire. EXTERNAL CLEANING: use a cloth moistened in lukewarm water and neutral detergent (for painted hoods); use specific products for steel, copper or brass hoods. Metal sponges, brushes, too hard brushes, very aggressive detergents, etc. ) Cleaning the grease filters WHEN TO CLEAN IT: clean it at least every 2 months to prevent the risk of fire. HOW TO REMOVE THE FILTERS: push the catch near the handle towards the rear of the hood and pull the filter downwards HOW TO CLEAN THE FILTERS: hand wash or in the dishwasher using a neutral detergent. If washing in the dishwasher, possible discoloration of the filters does not in any way compromise their functioning. HOW TO REMOVE IT: If using the hood in the filtering version, the charcoal filter will have to be replaced. [. . . ] There is a fire risk if cleaning is not carried out in accordance with the instructions. Replacing the lamps - To change the halogen lamps open the cover levering from the proper slots. Replace it with a lamp of the same type. [. . . ]