User manual GMC SIERRA DENALI 2004

[. . . ] Congratulations on your purchase of a GMC Sierra or Sierra Denali. Please read this information and your Owner Manual to ensure an outstanding ownership experience. Note that your vehicle may not include all the features described in this booklet. Place this booklet in your Owner Manual portfolio for easy reference. INSIDE YOUR VEHICLE Instrument Panel . [. . . ] : Clears rear glass of fog/frost and activates heated outside rearview mirrors (if equipped). : Turns the air conditioning system on and off. The button's LED will illuminate when the air conditioning system is on. Note: When the climate control system is in the OFF position ( ), outside air will continue to enter the vehicle and will be directed according to the mode position selected. This is normal climate control operation. See Section 3 of your Owner Manual. Set the time on radios without a Radio Data System (RDS) · Press and hold the HR or MIN arrow for two seconds. · Press the HR (down) arrow until the correct hour appears on the display. · Press and hold the MIN (up) arrow until the correct minute appears on the display. Note: The time may be set with the ignition on or off. 7 Set the time on radios with a Radio Data System (RDS) Your radio may have a button marked "H" or "HR" to represent hours and an "M" or "MIN" to represent minutes. · Press and hold the hour button until the correct hour appears on the display. · Press and hold the minute button until the correct minute appears on the display. Program radio station presets · Turn the radio on. · Press BAND to select the band (AM, FM1/FM2/XM1/XM2). · Use the seek or tune knob to tune in the desired station. · Press AUTO EQ or AUTO TONE (as applicable to your radio) to select the equalization that best suits the type of station selected. · Press and hold one of the six numbered buttons until a beep sounds; release the button. · Repeat these steps for each station preset, using a different numbered button for each station. Access one of the two available XM Satellite Radio bands (if equipped) · Press the BAND button until XM1 or XM2 appears on the display. Note: Requires subscription to XM Radio. Six-Disc CD Changer (if equipped) B A Loading/Unloading Quick Load · Press LOAD ("A" above) for approximately three seconds. · Wait for amber lights to flash on sides of slot ("B" above) before inserting CD. The next available number will flash and accept another CD until all are occupied. · To exit Quick Load, press either a number with a CD in it or LOAD. Quick Unload · Press EJECT for approximately three seconds; all CDs will eject from highest number to lowest. Load 1 CD · Press LOAD; all available numbers will flash amber. · Wait for amber lights to flash on sides of slot before inserting CD. [. . . ] Seat Position Recall On Remote Easy Exit Driver Seat 1. Adjust the seat to the desired position. Press and hold the exit button ( ) on the driver's door until two chimes sound. (Note: Seat Exit must be "On" in your programmed settings. ) Headlamp On at Exit 1. [. . . ]