User manual GN NETCOM GN 9050

[. . . ] The Headset Mode light on the Remote blinks, and the Headset Mode light on the Base illuminates. It will take up to 45 seconds to establish a channel with first use. 8 9 10 10 Transmit Settings: Adjusts the volume of your voice. 1 is the softest, 8 is the loudest. Telephone Compatibility Settings: Fine tunes the system to your telephone system. Bass/Treble Tone Settings: 3-position switch to customize receive tone. Audio Indicators Out of Range Mute Low Battery Volume Headset/Handset Mode Tone sounds in headset every 10 seconds Tone sounds in headset every 15 seconds Tone sounds in headset every 20 seconds Battery Information Battery Type Nickel Metal Hydride (NiMH), 3. 6 V 450 mAH (GN Netcom part number 1601-809) Fully charged battery provides minimum of 6 hours continuous use without recharging. The base has two charging ports; additional battery can be purchased for longer operation. Fully charged battery provides minimum 80 hours without recharging. Maximum 3 hours to completely recharge a discharged battery; battery cannot be overcharged. [. . . ] Put the Headset on and select a telephone compatibility setting until dial tone is clear. If dial tone is clear for both A and G, set to A. Most phones will require setting A or G. 11. To customize the receive tone, adjust the 3-position switch. Top: Increase Treble Mid: Neutral Bottom: Increase Bass A B C D E F G 9. Remove the handset and make a call. While switching between the Headset and Handset, adjust the transmit (microphone) setting until your voice is the same volume on both devices (1 is the softest, 8 is the loudest). Disconnect the optional Remote Handset Lifter from the Base while setting the volume. 1 2 3 4 5 6 7 8 A B C Adjusting Remote Beltpack Ring Tone Press the Headset/Handset Button on the Remote to put the system in Handset Mode (the indicator lights on the Remote and Base are not illuminated). Simultaneously press the increase Volume Button (+) as well as the Mute Button for 3 seconds and release. The Headset Mode Indicator light on the remote lights up indicating you are in Ring Setting Mode. Use the Volume Control on the Remote to select one of the four available options: Maximum, Medium, Minimum, Mute. Press + to increase the volume of the ring and press - to decrease or mute the ring tone. Within 10 seconds, the setting will be stored and the Headset Mode Indicator light will go out. 4 5 Frequently Asked Questions What should I check if I don't hear a dial tone?· Check to see that all cords and jacks are connected. · Make sure that the Headset cord is fully inserted into the Remote. · Make sure that the AC Adapter is plugged in and has power. · Try the compatibility setting on A and G. · Make sure the system is in Headset Mode. · Make sure that the Battery is properly installed in the Beltpack. · Make sure that the Battery is fully charged (3 hours minimum). · Check that the serial numbers on the bottom of the Base unit and back of Beltpack units match; because of the security circuits, the Beltpack and Base unit must match for operation. [. . . ] What should I do if I hear noise or static or if the signal is weak?· You may be out of range; move closer to the Base for a stronger signal. What should I do if my battery is not charging?· Remove the Remote from the Base Charger and wipe the battery charging contacts on the back of the Remote/Battery. [. . . ]