User manual GN NETCOM HT-TWO

[. . . ] A flashing light indicates an incoming call. Mute Switch In the "on" position the user will not be overheard by the person on the other end of the line. When activated, the mute LED flashes to indicate the microphone is muted. Volume Switch Sliding toward "high" increases your receive volume, while sliding toward "low" decreases the audio receive. Tone Ringer The HT-Two provides an audible tone ringer through the headset when there is an incoming call. Ring Adjustment To adjust the tone ringer sound level to the headset, slide the coverplate to the left and lift off. While the phone is ringing, turn the rotary switch to increase or decrease ringer volume. Quick Disconnect Connecting Equipment Before connecting the HT-Two to your PC or phone system, the "phone" switch must be in the "off" position. Receiving and Placing Calls Receiving A Call When there is an incoming call, simply move the "phone" switch to the "on" position and answer the call. At the conclusion of the call, position the switch in the "off" position. [. . . ] Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. The equipment must also be installed using an acceptable method of connection. The customer should be aware that compliance with the above conditions may not prevent degradation of service in some situations. Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any repairs of alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment. Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas. CAUTION: Users should NOT attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate. NOTICE: The Ringer Equivalence Number (REN) assigned to each terminal device provides an indication of the maximum number of terminals allowed to be connected to a telephone interface. The termination of an interface may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed 5. Warranty GN Netcom, Inc. warrants this product against all defects in material and workmanship for a period of two years from the date of original purchase. The conditions of this warranty and our responsibilities under this warranty are as follows: · The warranty is limited to the original purchaser. · The warranty is void if the serial number, date code label or product label is removed, or if the product has been subject to physical abuse, improper installation, modification, or repair by unauthorized third parties. · The responsibility of GN Netcom, Inc. under this warranty shall be limited to the repair or replacement of the product at the sole discretion of GN Netcom, Inc. · Any implied warranty on GN Netcom, Inc. products is limited to two years from the date of purchase on all parts, including the cords and connectors. Specifically exempt from warranty are limited-life consumable components subject to normal wear and tear, such as microphone windscreens, ear cushions, ear tips, decorative finishes, batteries, and other accessories. [. . . ] In-warranty products are warranted for one year from the repair date or for the remainder of the original warranty period, whichever is longer. Out of warranty products will be repaired or replaced at the prevailing charge and carry a one year warranty from repair date. will not assume any responsibility for any loss or damage incurred in shipping. products by unauthorized third parties voids any existing GN Netcom, Inc. [. . . ]