User manual GOLDEN STATE INTERNATIONAL 40-288

[. . . ] Press and hold "B" for 3 seconds to change from 12 to 24 hour format, and vice versa. Alarm Setting 1. Press "C" to enter alarm setting function. The minutes field will start blinking. 2. Press "D" to change the time zone displayed. Time zone is based on GMT (Greenwich Mean Time) +/1, 2, 3 up to 12 hours. 3. Press "C" to set time zone. Time Setting 1. Press and hold "C" for 3 seconds to enter time setting mode. [. . . ] Lap Time · In stopwatch mode, press "C" to reset to zero. "B" "C" A. Set 3. Next, press "C" and DST ­ Daylight Savings time will begin to flash. 4. Press "D" to change the hours, press and hold to scroll quickly through numbers. · Press "D" to start the stopwatch. DISPLAY · The screen shown in display layout: 4. Press "D" to change DST from on to off and vice versa. 5. Press "B" to exit the alarm setting function at any point. 5. Press "C" to change the "seconds" field. · Press "D" again to stop the stopwatch. Month Day Date Second WORLD TIME 6. Press "D" to set "seconds" to zero. · In the world time mode, press and hold "D" for 3 seconds to set Daylight Savings Time (DST) On/Off alternately. Split Time 1. In stopwatch mode, press "D" to start the stopwatch. Hour Minutes 7. Repeat steps 5 & 6 to set the following fields in sequence: Minutes, hours, year, month and date. The watch will not allow you to change the seconds/ minutes/ hours if the watch has been successfully calibrated in the last 24 hours. 2. Press "C" to display the split time. Stopwatch continues timing internally MODE SELECTION · Press "B" to change modes in the following sequence: a) Timekeeping mode b) Alarm mode c) World time mode d) Stopwatch mode · Press and hold "B" for 3 seconds to change 12H/24H format. In the 12 hour format, a small A or P icon will be displayed. 3. Press "C" again to clear the split time and continue the measurement. 8. Press "B" to exit time setting function at any point. TIME CALIBRATION cont'd LIMITED WARRANTY cont'd Please note that GSI reserves the right to substitute a watch of equal or greater value and similar appearance to the returned watch on both in-warranty and out-of-f warranty returns/repairs. For best results place the watch flat on a stable surface with its 12 o'clock position facing in the general direction of Fort Collins, Colorado. Do not move the watch during the calibration process. When the watch tries to receive the signal, the reception icon will flash on the upper right corner of the display. Signal strength is displayed in bar graph format. If calibration is successful, the radar icon will remain ON. Important Factors for Time Calibration Signal Reception 2 YEAR LIMITED WARRANTY The inner components of this watch are warranted to be free from defects in materials and manufacturer's workmanship for two years from the original date of purchase. Receipt required for proof of purchase date. This warranty does not apply to normal wear and tear or abuse, and excludes the battery, crystal, strap or bracelet. It does not cover costs, parts, labor, defects or damage caused by any source other than Golden State International. Warranty will be void if there is evidence that the case back has been tampered with. Within this warranty period, if you return your watch due to a manufacturer's defect, there are no shipping and handling charges. If the warranty period has expired, there is a US$5. 00 shipping charge. [. . . ] If you would like the battery, case crystal and/or strap replaced, please see the pricelist of additional charges below. We recommend that you do not get leather straps wet as moisture may cause discoloration. Water Resistance ­ Exposure to moisture may result in rust and failure of metal and/or mechanical portions of a watch. Only watches with the words "water resistant" engraved on the back of the watch may be safely submerged in water. [. . . ]