User manual GOLDEN STATE INTERNATIONAL 40-402

[. . . ] - modello - model - modèle - modell - model - modelo - modelo - model - model - model - modell - model - modello - model - modèle - modell - model - modelo - modelo - model - model - model - modell - model 4 Kundendienst Bevor Sie sich an den Kundendienst wenden: • Prüfen Sie, ob die Störung selbst behoben werden kann (siehe Störungen und Abhilfe). U moet doorgeven: • het type storing • het model apparaat (Mod. ESTAMOS A SU SERVICIO - modello - model - modèle - modell - model - modelo - modelo - model - model - model - modell - model - modello - model - modèle - modell - model - modelo - modelo - model - model - model - modell - model 5 Assistência Antes de contactar a Assistência técnica: • Verifique se pode resolver sozinho a anomalia (veja as Anomalias e Soluções). - modello - model - modèle - modell - model - modelo - modelo - model - model - model - modell - model - modello - model - modèle - modell - model - modelo - modelo - model - model - model - modell - model 6 Mielőtt szerelőhöz fordulna: • Ellenőrizze, hogy a hibát nem tudja-e elhárítani (lásd Hibaelhárítás). [. . . ] B A B A B Pure Wind maximises air circulation, improving the efficiency of the evaporator and helping to achieve the optimal temperature inside the refrigerator as quickly as possible each time it has been opened. The blown air (A) is cooled when it comes into contact with the cold wall, whereas the hotter air (B) is sucked up (see diagram). The Pure Wind Plus products are also equipped with a filter which, thanks to the inclusion of silver ions, makes it possible to reduce bacteria by 70% and to eliminate odours inside the refrigerator unit, thereby guaranteeing improved food storage. If the TEMPERATURE ADJUSTMENT knob has been set on high values with large quantities of food and with a high ambient temperature, the appliance can operate continuously, resulting in excessive frost formation and excessive energy consumption: compensate for this by shifting the knob towards lower values (defrosting will occur automatically). Static Models without the Aircooler have the cooling section in the internal back wall of the compartments. The wall will be covered in frost or water droplets depending on whether the compressor is operating or paused: both cases are normal. If the TEMPERATURE ADJUSTMENT knob has been set on high values with large quantities of food and with a high ambient temperature, the appliance can operate continuously, resulting in excessive frost formation and excessive energy consumption: compensate for this by shifting the knob towards lower values (defrosting will occur automatically). In static appliances, the air circulates in a natural way: the colder air tends to move downwards as it is heavier. The food should be stored as follows: With the Active Oxigen switched on, the device will operate a repeted cycle until the key is pressed again. There will be an Ozone emission noticed by the switching on of the green led located on the Active Oxigen device located in the fridge compartment and a stand-by cicle (without zone emission) noticed by blue light. Using the refrigerator to its full potential • Use the TEMPERATURE ADJUSTMENT knob to adjust the temperature (see Description). This will help maintain the temperature inside the freezer, ensuring that foods are conserved for at least 9 -14 hours. If the room temperature drops below 14°C for an extended period of time, the ideal temperature will not be reached in the freezer compartment and food preservation will be reduced. Defrosting the freezer compartment If the frost layer is greater than 5 mm, it is necessary to defrost manually: 1. Set the TEMPERATURE ADJUSTMENT knob to the position OFF 2. Wrap frozen foods in newspaper and place them in another freezer or in a cool place. Leave the door open until the frost has melted completely. This can be made easier by placing containers with lukewarm water in the freezer compartment. Clean and dry the freezer compartment carefully before switching the appliance on again. Certain appliances are fitted with the DRAIN SYSTEM to lead the water outside: let the water flow into a container (see diagram). GB Maintenance and care Switching the appliance off During cleaning and maintenance it is necessary to disconnect the appliance from the electricity supply. It is not sufficient to set the temperature adjustment knobs on OFF (appliance off) to eliminate all electrical contact. [. . . ] € The outside ambient temperature is very high. • The thickness of the frost exceeds 2-3 mm (see Maintenance). € The appliance has not been installed on a level surface (see Installation). € The appliance has been installed between cabinets that vibrate and make noise. [. . . ]