User manual GORENJE FH451CW

[. . . ] We thank you for the confidence you have shown by purchasing our appliance. We wish you find a lot of pleasure in its use. The freezer chest is intended for use in household, for freezing fresh food and long-term storage of frozen food (up to one year, depending on the type of food). temperature in the appliance interior is -18°C or lower. [. . . ] Maximum environment temperature at which the appliance will still operate correctly depends on the make (class) of your appliance, as indicated on the rating plate. Environment temperature from +10°C to +32°C from +16°C to +32°C from +16°C to +38°C from +16°C to +43°C A damp cellar or basement is not an appropriate place for a freezer chest; the same applies for a balcony or other place where the appliance would be exposed to direct sunlight. The freezer chest must be placed on dry and sufficiently solid surface which allows it to stand stably and horizontally even when fully loaded. The appliance should not be integrated in a cupboard or other furniture. Allow at least 2-3 centimeter of clearance around the chest for free circulation of air. Clearance from the wall on the back is defined by the hinge. The appliance is fitted with a condenser unit which radiates Heat into the environment. The condenser unit is installed on the back wall, directly underneath the sheet metal layer of the back and front wall of the appliance. For correct operation, allow sufficient cooling of these surfaces; do not block them or line them with any objects. Connect the appliance to the power mains using a connection cable. The wall outlet should be fitted with a ground contact (safety socket). The specified nominal voltage and frequency are indicated on the appliance rating plate. The appliance must be connected to the power mains and grounded in compliance with the effective standards and regulations. The appliance will withstand short-term deviations from the nominal voltage, but not more than +/- 6%. The appliance should not be integrated in a cupboard or other furniture. Allow at least 2-3 centimetres of clearance around the chest for free circulation of air. With models with a visible condenser unit installed on the back wall, make sure the clearance from the wall is at least 70 mm (see figure). With models with a condenser unit installed directly under the sheet metal cover on the back wall of the appliance, the clearance from the wall is defined by the hinge. A Temperature settings knob ­ Switching the appliance on/off ­ Activating the super freeze function B Signal light on: Super freeze function is activated C Signal light on: The appliance is powered (there is voltage in the appliance) D Signal light on: High temperature alarm Switching on: rotate the thermostat knob A clock wise towards the Max. When the appliance is switched on for the first time, the D signal light will be on. It will go off automatically when the freezer cools down to a temperature that no longer presents danger of food spoilage. Switching off: Rotate the A knob back to the position in which the arrow is aligned with the symbol (appliance will remain powered, i. [. . . ] Rotate the knob clockwise to a position between min. Thermostat knob set to a setting that is too low. Rotate the thermostat knob A towards the min. Make sure the air can circulate freely at the back and front wall of the appliance. [. . . ]