User manual GORENJE G640AX1-236636

[. . . ] 1 Ultra rapid gas burner 2 Rapid gas burner 3 Semirapid gas burner right front 4 Semirapid gas burner left back 5 Auxiliary gas burner 6 Enamelled steel pan support 2F 7 Central enamelled steel pan support 8 Burner n° 1 control knob 9 Burner n° 2 control knob 10 Burner n° 3 control knob 11 Burner n° 4 control knob 12 Burner n° 5 control knob 13 Electric ignition button Attention: this appliance has been manufactured for domestic use only and it employment by private person. A diagram is screen-printed above each knob on the front panel. This diagram indicates to which burner the knob in question corresponds. After having opened the gas mains or gas bottle tap, light the burners as described below: - Manual ignition Push and turn the knob corresponding to the required burner in an anticlockwise direction until it reaches the full on position (large flame fig. [. . . ] The adhesive used to stick the plastic laminate to the cabinet must be able to withstand a temperature of not less than 150° C otherwise the laminate could come unstuck. The appliance must be installed in compliance with the provisions in force. This appliance is not connected to a device able to dispose of the combustion fumes. It must therefore be connected in compliance with the above mentioned installation standards. Particular care should be paid to the following provisions governing ventilation and aeration. conditions: type of gas and working pressure. Gas connection must comply with the pertinent standards and provisions in force. When gas is supplied through ducts, the appliance must be connected to the gas supply system: o with a rigid steel pipe. The joints of this pipe must consist of threaded fittings conforming to the standards. The joints of this pipe must consist of unions with mechanical seals. o With seamless flexible stainless steel pipe. The length of this pipe must be 2 meters at most and the seals must comply with the standards. When the gas is supplied by a bottle, the appliance must be fuelled by a pressure governor conforming to the provisions in force and must be connected: o with a copper pipe. The joints of this pipe must consist of unions with mechanical seals. o With seamless flexible stainless steel pipe. The length of this pipe must be 2 meters at most and the seals must comply with the standards. it is advisable to apply the special adapter to the flexible pipe. This is easily available from the shops and facilitates connection with the hose nipple of the pressure governor on the bottle. o With rubber hose pipe in compliance with standards. The diameter of this hose pipe must be 8 mm and its length must be no less than 400 mm and no more than 1500 mm. It must be firmly fixed to the hose nipple by means of the safety clamp specified by standards. At the connection end, verify the gasproof using a soap solution, never a flame. [. . . ] 18 - 19) If a tap becomes stiff to operate, it must be immediately greased in compliance with the following instructions: - Remove the tap. - Clean the cone and its housing using a cloth soaked in diluent. - Lightly spread the cone with the relative grease. - Fit the cone back in place, operate it several times and then remove it again. [. . . ]