User manual GORENJE GV66261

[. . . ] Read the operating instructions and keep them in a safe place!Never use the dishwasher for any purpose other than that specified in these operating instructions. Do not load the dishwasher door or dishwasher baskets with anything other than dishes. Never leave the dishwasher door open as someone may trip on it. [. . . ] After a while, the dishwasher continues the programme. How to get the best drying results Place the dishes in the machine so that the rinse water Will run off them; this is especially important for plastic. Top up with rinse aid or increase the rinse aid dosage Allow the dishes to cool before unloading the dishwasher. Once the programme has finished The end of the programme is indicated by one short signal from the buzzer. The chapter Settings describes how to change this function. Moreover, the end of the programme is indicated by the status light turning off. See the section Status light in the chapter Using the dishwasher. The dishwasher switches off automatically after the programme ends. If the dishwasher is switched off using the main power switch or during a power cut During drying, the programme is interrupted if the power is cut or the door is open for more than 2 minutes. 1) Consumption values vary depending on the temperature of the incoming water, room temperature, load size, selected additional functions and more. Start the programme by activating the setting and then closing the door. The coarse filter traps larger food particles, which cannot get past the drainage pump. Debris that collects on the fine filter is automatically rinsed away during each wash. However, the fine filter and its pipe section should be cleaned a couple of times a year. 3 In order to inspect the drainage pump, remove the coloured stop on the right in the bottom drain. 4 By inserting your finger into the hole you can turn the pump blade to release anything blocking it. 5 Replace the drainage pump stop along with the fine and coarse filters. If the dishwasher still does not start and a whirring sound is heard, the overflow protection has been activated. Do not forget to replace the drainage pump stop. 2 Lift the filter straight up using the handle. Properly when replacing the fine filter. 4 Lock the filter in place by turning the handle clockwise to the stop position. [. . . ] Do not re-use old hoses or other spare supply hoses. The supply pipe must be fitted with a stopcock. The stopcock must be easily accessible, so that the water can be shut off if the dishwasher has to be moved. Once the installation is complete, the stopcock should be opened to allow the pressure to settle for a while and to check that all connections are tight. [. . . ]