User manual GOVIDEO R6750 Product Manual

[. . . ] 1 Congratulations! Congratulations on your purchase of this R6750 DVD Recorder. We know you will enjoy this product for many years to come. In case service is required, please take a moment to write down your serial number located on the rear panel of the DVD Recorder: ______________________________________________________ FCC Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] · To view the status of your recording, press DISPLAY. When finished, press STOP to stop recording. · The disc is updated with the new recording. This may take a few minutes to complete. · To watch your recording, see page 32. · To finalize your disc to play on other DVD players, see page 37. CH 25 EXIT NOTE: · You cannot change channels or record quality during recording. 4 - Operations 29 Recording from an External Source Recording from a VCR, Camcorder, etc. Follow these steps to record from a VCR, camcorder, or other external device. 1 Connect your external device to the front panel or rear panel inputs; see pages 18-19. 2 Insert a blank DVD+R or DVD+RW disc into the disc tray. · Press OPEN/CLOSE to open and close the disc tray. 3 Press INPUT repeatedly to select: AV1-Front - For a device connected to the front Audio/Video Input. AV2-Rear - For a device connected to the rear Audio/Video Input. S-Video - For a device connected to the rear S-Video Input. DV - For a device (such as a digital camcorder) connected to the front DV Input with a DV cable. · Press SETUP, then select Record>Quality; see page 25 for details. 5 Cue the device and start playback at the beginning of the scene you wish to record. 6 7 Press REC to start recording. · To pause recording, press PAUSE. · To resume recording, press PAUSE again. When finished, press STOP to stop recording. · The disc is updated with the new recording. This may take a few minutes to complete. · To watch your recording, see page 32. Connect a DV-compatible camcorder to the front panel DV jack with a IEEE1394 4-pin DV cable (not included). [. . . ] The batteries in the remote control are exhausted. Remove the obstacle. Replace the batteries with new ones. 40 DVD Recorder User's Guide Technical Specifications General Power Supply Power Consumption Operating Temp. Operating Humidity Dimensions (W/H/D) Net Weight Tuner Signal Tuner System AC 100~240V, 50/60 Hz 36 W 5~40°C (36°~104°F) 5~80% RH 420 x 66 x 268 mm 2. 8 kg UHF/VHF/CATV NTSC Audio Audio Formats Dolby Digital MPEG1 MPEG2 PCM DA Converter AD Converter Signal-Noise (1kHz) Dynamic Range (1kHz) Ch. Separation (1kHz) THD (1kHz) Multi-channel 2-channel Multi-channel 2-channel 24-bit/192KHZ 24-bit 90dB 80dB 80dB 65dB Audio Performance Connections Front Panel Video Input Audio L/R Input IEEE 1394 Input RCA Connector (yellow) x1 RCA Connector (white/red) x1 Mini jack x1 RCA Connector (yellow) x1 RCA Connector (white/red) x1 4-Pin Mini DIN x1 RCA Connector (yellow) x1 RCA Connector (white/red) x1 4-Pin Mini DIN x1 Y, Pb, Pr (Green/Blue/Red) x1 Coaxial x1 Optical x1 Video Video Formats · · MPEG2 for DVD+VR, DVD-Video, SVCD MPEG1 for DVD+VR, VCD 10-bit/54MHz 1 Vp-p 75 Ohm Y : 1 Vp-p 75 Ohm C: 0. 3 Vp-p 75 Ohm Y : 1 Vp-p 75 Ohm Pb : 0. 7 Vp-p 75 Ohm Pr : 0. 7 Vp-p 75 Ohm Rear Panel Video Input Audio L/R Input S-Video Input Video Output Audio L/R Output S-Video Output Component/ Prog. [. . . ]