User manual GOVIDEO VR1940 Product Manual

[. . . ] 1 Congratulations! Congratulations on your purchase of this VR1940 DVD Recorder+VCR. We know you will enjoy this product for many years to come. In case service is required, please take a moment to write down your serial number located on the rear panel of the DVD Recorder+VCR: ______________________________________ FCC Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] · To view the status of your recording, press DISPLAY. When finished, press STOP to stop recording. · If you are using a disc, it will be updated with the new recording. This may take a few minutes to complete. · To watch your recording, see page 39. · To finalize a disc to play on other DVD players, see page 44. EXIT DV 6 Use to select the channel you want to record, then press ENTER. · If you are using a cable box/satellite receiver, set the DVD Recorder+VCR to the receiver's output channel (2, DVD Recorder+VCR User's Guide NOTE: · You cannot change channels or record quality during recording. · While a VHS recording is in progress, you can play a DVD by pressing the DVD button and then pressing PLAY. · During VHS recording, you can also press GUIDER and select "Play Disc" , "Erase" or "Finalize" . 34 Recording from an External Source Recording from a Camcorder or other Device Follow these steps to record from a camcorder or other external device. 1 Connect your external device to the front panel or rear panel inputs; see pages 18-19. 3 Press INPUT repeatedly to select: AV1-Front - For a device connected to the front Audio/Video Input. AV2-Rear - For a device connected to the rear Audio/Video Input. S-Video - For a device connected to the rear S-Video Input. DV - For a device (such as a digital camcorder) connected to the front DV Input with a DV cable. 4 Press DVD to control the DVD deck or VCR to control the VCR deck. Disc Control Tape Control 7 When finished, press STOP to stop recording. · To watch your recording, see page 39. Connect a DV-compatible camcorder to the front panel DV jack with a IEEE1394 4-pin DV cable (not included). A single DV cable is used for input and output of audio, video, data, and control signals. After recording stops, a DV control bar appears on screen. You can use this control bar to Stop, Play, Pause, Fast-Forward, and Rewind the DV camcorder using your DVD Recorder+VCR remote control. Press REC repeatedly to add recording time in 30-minute blocks (up to 6 hours or the time remaining on the tape or disc). To cancel One-Touch Recording, press REC until "OTR" disappears from the on-screen display. Notes on DV Recording · · · One-Touch Recording · 5 6 Cue the external device and start playback at the beginning of the scene you wish to record. [. . . ] There is an obstacle in the path of the remote control and the DVD Recorder+VCR. The batteries in the remote control are exhausted. Remove the obstacle. Replace the batteries with new ones. 5 - Help 47 Technical Specifications General Power Supply Power Consumption Operating Temp. Operating Humidity Dimensions (W/H/D) Net Weight Tuner Signal Tuner System AC 100~240V, 60 Hz ~36 W 5~40°C (36°~104°F) 5~80% RH 420 x 90 x 268 mm ~2. 8 kg UHF/VHF/CATV NTSC-M Audio Audio Recording Format DVD+VR (HQ/SP/EP/SLP) Analog Output Digital Output Format Supported DA Converter AD Converter Signal-Noise (1kHz) Dynamic Range (1kHz) Ch. [. . . ]