User manual GP BATTERIES SS105

[. . . ] Plug the DC jack of the adaptor into the DC charging socket on SecureStartTM. Your SecureStartTM will begin charging upon switching on the wall adaptor. Minimum 4 hours or permanently plugged-in charging. To maximize SecureStartTM performance, permanent plugged-in charging is recommended. [. . . ] ONLY after removing and storing the Black negative (-) cable clamp, disconnect the Red positive (+) cable clamp last from the vehicle battery positive (+) terminal and place it to its storage position in your SecureStartTM. It is mandatory to recharge your SecureStartTM immediately with wall adaptor for at least 4 hours. Note: The SecureStartTM has successfully cranked on 12L diesel engine. 5. Fuel gauge indication: · · RED GREEN : Immediately recharge your SecureStartTM : Ready to jump-start · As fuel gauge traces the battery voltage, the indication may not be accurate right after the unit is unplugged from the charging. Please check the fuel gauge after 30 minutes rest from charging. Recommended to plug in the wall adaptor when not in used. It is recommended to store your SecureStartTM in a cool, dry location to maximize its performance. Failure to follow the charging instructions may shorten your unit's service life. 2 3 Warranty Terms and Conditions Your SecureStartTM is covered by a conditional, limited warranty to the original purchaser. Your SecureStartTM is warranted to be free from defects in material and workmanship for a limited period (as stated on card) from the date of sale. If your jumpstart unit malfunctions or fails within the warranty period because of a defect in material or workmanship, we will repair or replace it, at our discretion, without charge. You must present a sales invoice or receipt to prove the date of purchase. If the warranty seal sticker is damaged, the warranty shall be voided. Returned units determined to have been subjected to misuse shall not be covered under warranty. This warranty does not cover defects or failures of your SecureStartTM due to any cause other than defective manufacturer's material or workmanship, including without limitation any malfunctions or failures caused by repairs made by an unauthorized person, mishandling, modifications, normal wear, unreasonable use or damage. IN NO EVENT SHALL THE MANUFACTURER BE LIABLE FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES. EXCEPT FOR THIS LIMITED WARRANTY, THE MANUFACTURER HAS NOT MADE, AND SPECIFICALLY DISCLAIMS, ANY WARRANTY OR REPRESENTATION OF ANY KIND, EXPRESS OR IMPLIED, DIRECT OR INDIRECT, OF PRODUCT FITNESS FOR A PARTICULAR PURPOSE. THIS LIMITED, CONDITIONAL WARRANTY PROVIDES THE EXCLUSIVE REMEDY FOR ANY CLAIM OR DAMAGE EXCEPT AS OTHERWISE REQUIRED BY LAW. IMPORTANT Read All Instructions And Safety Warnings Before Using SecureStartTM Warning / Safety Information 1. Read and follow all instructions in this manual before using the SecureStartTM. Follow all instructions published by the automobile and vehicle battery manufacturers, especially the procedure of jump-starting of a vehicle. NEVER ALLOW cable clamps ("+" & "-") to TOUCH each other. Cable clamps are "live" at all times, and will spark once they touch, SecureStartTM will generate heat too. Always ensure clamps are stowed securely in clamp holders when not connected for jump-starting. [. . . ] The TMF power pack contained within your unit is capable of generating very high current. This current may cause severe burns or personal injury. Use your SecureStartTM to jump-start vehicles that run with lead-acid battery only. Never immerse SecureStartTM into water or seawater. [. . . ]