User manual GRACO AUTOCLEAN2 309955F

[. . . ] Symbols appearing in the body of the manual refer to these general warnings. When these symbols appear throughout the maual, refer back to these pages for a description of the specific hazard. This may look like just a cut, but it is a serious injury that can result in amputation. Do not point gun at anyone or at any part of the body. [. . . ] To Repeat AutoClean: Turn pressure control knob to lowest setting or Turn power switch OFF. turn power switch ON and Repeat steps 1 and 2. OR For sprayers with mechanically actuated AutoClean: turn valve to prime position and then back to AutoClean to repeat cycle. 4 When finished, remove trigger clip from gun handle. With clean fluid, briefly trigger gun into waste pail several times to clear any debris from front of gun. Briefly trigger gun into waste pail to clean tip. This is also recommended as preventive maintenance when repacking pump. 2 Thread valve onto end of gun and open valve. When check is not OK refer to this column. Gun trigger and prime valve must both be open. If prime valve is closed, system may pressurize to stall - open prime valve. System runs in AutoClean mode but does not clean filter. Make sure AutoClean valve is open and is screwed completely onto gun. Run AutoClean cycle with warm soapy water or mineral spirits to flush contaminants from valve. Pressure must be less than 200 psi, and motor must be stopped in order to get timer mode. Graco warrants all equipment referenced in this document which is manufactured by Graco and bearing its name to be free from defects in material and workmanship on the date of sale to the original purchaser for use. With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of 12 months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective. This warranty applies only when the equipment is installed, operated and maintained in accordance with Graco's written recommendations. This warranty does not cover, and Graco shall not be liable for general wear and tear, or any malfunction, damage or wear caused by faulty installation, misapplication, abrasion, corrosion, inadequate or improper maintenance, negligence, accident, tampering, or substitution of non-Graco component parts. Nor shall Graco be liable for malfunction, damage or wear caused by the incompatibility of Graco equipment with structures, accessories, equipment or materials not supplied by Graco, or the improper design, manufacture, installation, operation or maintenance of structures, accessories, equipment or materials not supplied by Graco. [. . . ] ), are subject to the warranty, if any, of their manufacturer. Graco will provide purchaser with reasonable assistance in making any claim for breach of these warranties. In no event will Graco be liable for indirect, incidental, special or consequential damages resulting from Graco supplying equipment hereunder, or the furnishing, performance, or use of any products or other goods sold hereto, whether due to a breach of contract, breach of warranty, the negligence of Graco, or otherwise. TO PLACE AN ORDER, contact your Graco distributor, or call 1-800-690-2894 to identify the nearest distributor. [. . . ]