User manual GRACO JUNIOR MINI

[. . . ] Do make sure that this car seat is suitable to use on your vehicle, and please consult your vehicle owner’s manual if you are uncertain. Seat belts may differ in design and length according to maker, manufacturing date, and type of the vehicle. Only suitable for use in the listed vehicles fitted with 3-point retractor safety-belts, approved to ECE Regulation No. Read this instruction carefully before installing your car seat. [. . . ] Shoulder harnesses Height Adjustment Improper adjustment of shoulder height may throw your child off the car seat when accident occurs. Make sure the shoulder height is not too high or too low before installing this car seat. 1 Open the rear cover located at the seat back (Fig. 7) 2 Move the slide lever up or down by pressing the harness height adjuster button (Fig. There are four pitches of shoulder height for adjustment. 3 Adjust the shoulder harness to appropriate height of insertion outlet cover after the height adjustment (Fig. 16 4 The shoulder harness MUST lay across child’s shoulders according to height (Fig. GB Installation to the Vehicle (Rear Facing Mode, for child under 13 kg)  Note that this mode must ONLY be used for child weighing under 13 kg (approximately 1 year old or under) (Fig. DO NOT install on vehicle seat equipped with safety airbags (Fig. It is highly recommended to have your car seat installed at the back seats of your vehicle. Note that you MUST adjust the car seat to the most reclining angle, or angle 5, in rearfacing Mode. Place the seat belt through the lock-off latch and pull it tight. 4 Recheck if the car seat is securely fitted after completing the above operation. (Check by moving the car seat back and forth) Make sure that both the lap belt and diagonal belt are not twisted or folded, and will not prevent the vehicle seat belt to be fully and rightly functioned. DO NOT insert the top bar in forward facing mode (Fig. Securing your Child in the Vehicle DO NOT remove the protective shoulder straps, which is designed to prevent your child from slipping. 1 Press the red button to release the harness buckle (Fig. 2 Loosen the harness by pressing the harness adjuster and adjust the shoulder harness to suitable length (Fig. 3 Attach both shoulder straps together then insert it into the harness buckle (Fig. 4 Pull the harness adjuster webbing to adjust the shoulder strips to suitable length that allow your child tightly secured at the car seat (Fig. Care and Maintenance 1 The seat pad is removable. Use cold water for hand washing and refer to the washing label attached on the car seat for correct method. [. . . ] Additional Information 1 Make sure that your car seat is securely fastened in the vehicle when not in use in case it throws around and injures occupants in a sharp turn, sudden stop or collision. 2 DO NOT make any modification to the structure or safety belt system of the car seat. For your child’s safety, DO check or immediately replace your car seat after an accident of any kind. 3 It is highly recommended that any luggage or other objects to be fastened up, they are liable to cause injuries in the event of a collision. [. . . ]