User manual GRACO PUMP-MANIFOLD KITS

[. . . ] Open the back pressure regulator and all fluid drain valves in the system, having a waste container ready to catch drainage. Leave open until you are ready to pressurize system again. Check that pressure gauges on fluid supply and return lines read zero. If gauges do not read zero, determine cause and carefully relieve pressure by VERY SLOWLY loosening a fitting. [. . . ] Be careful not to lose the collars (13). Shut off electrical power and allow the unit to cool. 311611D 3 Kit Installation Reassembly 1. Install the coupling nut (14) on the lower's piston rod (PR). Orient the lower (22) to the gear reducer (GR) as shown. Screw the tie rod locknuts (15) onto the tie rods handtight. Assemble the inlet and outlet manifolds (17) to the lower, using new gaskets (16) and clamps (18). Torque the clamps (18) to 15-20 ft-lb (21-27 N·m). Torque the locknuts (15) to 50-60 ft-lb (68-80 N·m). On pumps with a sensor circuit: Install a new black o-ring (41) on the transducer (25a). Insert the transducer into the outlet manifold (17). Torque the adapter (42) first, then the nut (43) to 15-20 ft-lb (21-27 N·m). On pumps without a sensor circuit: Install a black o-ring (41) on the plug (45). Screw the plug into the outlet manifold (17) and torque to 15-20 ft-lb (21-27 N·m). 6. Install a black o-ring (41) on the plug (45). Screw the plug into the inlet manifold (17) and torque to 15-20 ft-lb (21-27 N·m). Ensure that the collars (13) are in place in the coupling nut (14). wrench on the flats of the slider piston (9), to keep it from turning when you are tightening the coupling nut (14). Orient the wrench so it is braced against one of the tie rods (3) or pump stand. Tighten the coupling nut (14) onto the slider piston (9) and torque to 75-80 ft-lb (102-108 N·m). Turn on power and jog the motor to bring the other drive to the bottom of its stroke. Repeat procedure to connect the other lower. NOTE: Update the drive software to reflect the change in size of the lowers. [. . . ] In no event will Graco be liable for indirect, incidental, special or consequential damages resulting from Graco supplying equipment hereunder, or the furnishing, performance, or use of any products or other goods sold hereto, whether due to a breach of contract, breach of warranty, the negligence of Graco, or otherwise. FOR GRACO CANADA CUSTOMERS The Parties acknowledge that they have required that the present document, as well as all documents, notices and legal proceedings entered into, given or instituted pursuant hereto or relating directly or indirectly hereto, be drawn up in English. Les parties reconnaissent avoir convenu que la rédaction du présente document sera en Anglais, ainsi que tous documents, avis et procédures judiciaires exécutés, donnés ou intentés, à la suite de ou en rapport, directement ou indirectement, avec les procédures concernées. Graco Information For the latest information about Graco products, visit www. graco. com. TO PLACE AN ORDER, contact your Graco distributor or call to identify the nearest distributor. [. . . ]