Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual GRACO TWISTORK. We hope that this GRACO TWISTORK user guide will be useful to you.
Lastmanuals help download the user guide GRACO TWISTORK.
Detailed instructions for use are in the User's Guide.
[. . . ] This equipment has a 100 psi (7 bar) maximum working pressure. D Use fluids and solvents that are compatible with the equipment wetted parts. Refer to the Technical Data section of all equipment manuals. Read the fluid and solvent manufacturer's warnings. [. . . ] Proper grounding is an essential part of maintaining a safe system. To reduce the risk of static sparking, and all electrically conductive objects or devices in the dispensing area must be properly grounded. Check your local electrical code for detailed grounding instructions for your area and type of equipment. To ground the dispenser, connect the end of the ground wire (4) to a true earth ground. See the Parts Drawing on page 6.
NOTE: This unit is shipped with the ground wire attached to the grounding strip on the pump and to the grounding lug on the agitator. The ground wire must always be attached to these two places during use.
WARNING
TIPPING HAZARD This unit should be used only on flat, level surfaces. Uneven or slanted surfaces could cause the drum to tip over. Do not transfer drums with the unit mounted in the bung hole. When the unit is mounted in the bung hole, the center of gravity is too high for stability during transfer and could tip over. If possible, before you tighten the bung connection, rotate the unit so the agitator air motor is as close as possible to the center of the drum. That will improve the center of gravity and reduce the tipping hazard.
Operation
Pressure Relief Procedure
See the Parts Drawing on page 6. NOTE: The pump was tested with lightweight oil, which is left in the fluid passages to protect parts. To avoid contaminating your fluid with oil, flush the pump with a compatible solvent before using the equipment. D You must ensure that the agitator is stopped any time it is not contained in the drum. D Operate the pump by opening and closing the ball valve (17). Operate the agitator by adjusting the needle valve. See the pump manual and the agitator manual for detailed operating instructions. NOTE: For stopping the pump and agitator in emergencies, disconnect the air line from the quick-disconnect air line fitting (14). D When you lift the unit from the bung-mounted position, lift the unit with the aid of an overhead hoist hooked up to the lift hook (9).
WARNING
PRESSURIZED EQUIPMENT HAZARD The equipment stays pressurized until pressure is manually relieved. To reduce the risk of serious injury from pressurized fluid, accidental spray, or splashing fluid, follow this procedure whenever you: D D D D Are instructed to relieve pressure Stop dispensing Check, clean, or service any system equipment Install or clean dispensing nozzles
1. Open the dispensing valve to relieve all fluid pressure, and have a container ready to catch the drainage.
4
308656
Service
See the individual component instruction manuals for service instructions specific to the agitator and the pump.
CAUTION
Before operation, tighten the bung connection firmly by hand, and check it periodically during operation for tightness. See the Parts Drawing on page 6.
Parts List
Husky/Twistork Package, Model 238859, Series B Includes items 1, 3 through 20 Husky/Twistork Package, Model 238860, Series B Includes items 2 through 20
Ref No. [. . . ] This warranty applies only when the equipment is installed, operated and maintained in accordance with Graco's written recommendations. This warranty does not cover, and Graco shall not be liable for general wear and tear, or any malfunction, damage or wear caused by faulty installation, misapplication, abrasion, corrosion, inadequate or improper maintenance, negligence, accident, tampering, or substitution of nonGraco component parts. FOR GRACO CANADA CUSTOMERS The parties acknowledge that they have required that the present document, as well as all documents, notices and legal proceedings entered into, given or instituted pursuant hereto or relating directly or indirectly hereto, be drawn up in English. Les parties reconnaissent avoir convenu que la rédaction du présente document sera en Anglais, ainsi que tous documents, avis et procédures judiciaires exécutés, donnés ou intentés à la suite de ou en rapport, directement ou indirectement, avec les procedures concernées.
Graco Information
For the latest information about Graco products, visit www. graco. com. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE GRACO TWISTORK
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual GRACO TWISTORK will begin.