User manual GRACO XTREME PACKAGES 311164F

[. . . ] Instructions - Parts Xtreme Packages High performance, high pressure spray packages for protective coatings. Important Safety Instructions Read all warnings and instructions in this manual. Save these instructions. 311164F ENG Patent Pending See page 4 for model information and maximum working pressures. r_x25dh1_x45dl1_311164_1f II 2 G Contents Related Manuals . 7 Component Identification - Cart Mount . 9 Component Identification - Wall Mount . [. . . ] W TI8215a UT ST PF RK T TI8623b FIG. DataTrak Controls and Indicators 311164F 19 DataTrak Operation DataTrak Operation NOTE: DataTrak is included with certain models. See Models, page 4, for a list of models featuring DataTrak. NOTE: The DataTrak display (Y) will turn off after 1 minute to save battery life. Press any key to wake up the display. Run Mode Runaway 1. If pump runaway occurs, the runaway solenoid will actuate, stopping the pump. The LED (W) will flash and the display (Y) will indicate a runaway condition (see Table 3). To reset runaway monitor, close master air valve (B). Wait for air to completely bleed off the air motor before going to step 3. The screen will change to indicate this, as shown below. Setup Mode 1. To enter settings for runaway, lower size, and flow rate units, and to enable runaway, E1, E2, and E5 error options, press to change the value, then B to save the value and move the cursor to the next data field. NOTE: When runaway, E1, E2, and E5 error options are enabled, a will appear on the setup screen. Move the cursor to the E5 error enable option field, then press once more to exit Setup mode. 3. Press to clear the diagnostic code and reset the runaway solenoid. 4. Open master air valve (B) to restart pump. NOTE: To disable runaway monitoring, go to setup mode and set runaway value (T) to 0 (zero) or disable (RT) (see FIG. 5). 20 311164F DataTrak Operation Prime/Flush 1. To enter Prime/Flush mode, press any key to wake up the display, then press . The Prime/Flush symbol will appear flashing in the display and the LED will flash . Display See FIG. The display (Y) will turn off after 1 minute of inactivity in Run mode or 3 minutes in Setup mode. NOTE: DataTrak will continue to count cycles when display is off. Diagnostics 2. While in Prime/Flush mode, runaway protection is disabled and the batch totalizer (BT) will not count. [. . . ] With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective. This warranty applies only when the equipment is installed, operated and maintained in accordance with Graco40 s written recommendations. This warranty does not cover, and Graco shall not be liable for general wear and tear, or any malfunction, damage or wear caused by faulty installation, misapplication, abrasion, corrosion, inadequate or improper maintenance, negligence, accident, tampering, or substitution of non-Graco component parts. Nor shall Graco be liable for malfunction, damage or wear caused by the incompatibility of Graco equipment with structures, accessories, equipment or materials not supplied by Graco, or the improper design, manufacture, installation, operation or maintenance of structures, accessories, equipment or materials not supplied by Graco. [. . . ]