User manual GRANDSTREAM GXW400X

[. . . ] Grandstream Networks, Inc. Analog IP Gateway GXW400x 4 or 8 FXS Ports GXW400x User Manual Firmware Version 1. 0. 0. 77 www. grandstream. com support@grandstream. com TABLE OF CONTENTS GXW400x User Manual WELCOME. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 GATEWAY GXW400X OVERVIEW . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 SAFETY COMPLIANCES. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 WARRANTY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Forward all WAN IP traffic to a specific IP address if no matching port is used by GXW400x or defined in port forwarding. Forwards a matching (TCP/UDP) port to a specific LAN IP address with a specific (TCP/UDP) port. NAT maximum ports NAT TCP timeout NAT UDP timeout Uplink Bandwidth Downlink Bandwidth Enable UPnP support Reply to ICMP on WAN port WAN side HTTP/Telnet Access Cloned WAN MAC Addr Enable LAN DHCP LAN Subnet Mask LAN DHCP Base IP LAN DHCP Start IP LAN DHCP End IP DHCP IP Lease Time DMZ IP Port Forwarding In addition to the Basic Settings configuration page, the end user also has access to the Device Status page. Grandstream Networks, Inc. GXW400x User Manual Firmware 1. 0. 0. 77 Page 21 of 37 Last Updated: 1/2008 TABLE 8: STATUS PAGE DEFINITIONS MAC Address The device ID in HEX format. Note there are separate MAC addresses for the WAN side and the LAN side. The LAN MAC address will be used for provisioning and can be found on the label coming with original box and on the label located on the bottom panel of the device. Shows WAN IP address of GXW400x Contains the product model info. Program: This is the main software release. Shows system up time since the last reboot. Shows whether the PPPoE connection is running if connected to DSL modem. Shows type of NAT the GXW400x is connected to via its WAN port. Displays relevant information regarding the individual FXS ports. Example: Port FXS1 FXS2 FXS3 FXS4 Hook On Hook Off Hook On Hook On Hook Registration Registered Registered Not Registered Registered DND No No No Yes Forward 613 614 Busy Forward Delayed Forward WAN IP Address Product Model Software Version System Up Time PPPoE Link Up NAT Port Status 615 ** FXS port 4 user has set Do Not Disturb. FXS port 1 user has set his calls to be forwarded unconditionally to ext 613 FXS port 2 user has set his calls to be forwarded to 614 when his phone is busy. FXS port 3 user is not registered with his SIP Server. ADVANCED USER SETTINGS Log-in to the Advanced User Configuration Page the same way as for the basic configuration page. Login using the following default password: "admin". FIGURE 3: SCREENSHOT OF ADVANCED USER CONFIGURATION LOGIN SCREEN Grandstream Device Configuration Password Login All Rights Reserved Grandstream Networks, Inc. 2005-2006 Advanced User configuration includes the end user configuration and advanced configurations including: SIP configuration, Codec selection, NAT Traversal Setting and other miscellaneous configuration. Grandstream Networks, Inc. GXW400x User Manual Firmware 1. 0. 0. 77 Page 22 of 37 Last Updated: 1/2008 Table 9: Advanced Configuration Page Definitions Admin Password Administrator password. Only the administrator can configure the "Advanced Settings" page. Password field is purposely left blank for security reasons after clicking update and saved. The maximum password length is 25 characters. This field defines the layer 3 QoS parameter which can be the value used for IP Precedence or Diff-Serv or MPLS. IP address or Domain name of the STUN server. This parameter specifies how often the GXW400x sends a blank UDP packet to the SIP server to keep the "hole" on the NAT open. [. . . ] The configuration file name should be in lower cases. FIRMWARE AND CONFIGURATION FILE PREFIX AND POSTFIX Firmware Prefix and Postfix allows device to download the firmware name with the matching Prefix and Postfix. This makes it the possible to store ALL of the firmware with different version in one single directory. Similarly, Config File Prefix and Postfix allows device to download the configuration file with the matching Prefix and Postfix. Thus multiple configuration files for the same device can be stored in one directory. [. . . ]