User manual GRANDSTREAM HANDYTONE QUICK INSTALLATION GUIDE

[. . . ] Commonly Asked Questions My HandyTone does not work. Check to ensure you have broadband connectivity. [. . . ] Disconnect the Ethernet cable from your computer and plug it into the WAN port of the HT. Connect the second Ethernet cable (included in package) to both the computer's Ethernet port and the HT Lan port. Connect your telephone to the `phone' port in the back of the HT using a phone line. Wait until the modem is fully powered before continuing with setup. (approximately 5 minutes to upgrade firmware) 8. Now you must configure your HT with the ITSP of choice. Router Set-up Grandstream HT Series Do not plug in the HT until instructed. Router set-up requires an additional LAN port on your router. Connect the Ethernet cable (included in package) to both the router's LAN port and the HT Wan port. Connect your telephone to the `phone' port in the back of the HT using a phone line. Power on the Cable/DSL modem and router. Wait until the modem and router is fully powered before continuing with set-up. (all lights green ­ usually two minutes) 4. [. . . ] You will need to know your type of internet connection, and your router/modem name and model. 4. Line (RJ-11) RJ11 FXS Port (Phone) +5V/1200mA RJ11 FXS Port (Phone) HT Quick Install Guide Page 2 HT Quick Install Guide Page 3 HT Quick Install Guide Page 4 HT Quick Install Guide Page 5 HandyTone Series Analog Telephone Adaptors/IADs Quick Installation Guide 1297 Beacon Street Brookline, MA 02445 617 ­ 566 ­ 9300 www. grandstream. com support@grandstream. com Updated ­ 11/2006 [. . . ]