User manual GRASS VALLEY T2 ADDENDUM FOR SP3

[. . . ] T2 INTELLIGENT DIGITAL DISK RECORDER Users Manual (Addendum for SP3) F2431012012 November, 2010 Copyright Copyright © 2010 Technicolor dba Grass Valley. Portions of software © 2000 ­ 2010, Microsoft Corporation. This document may not be copied in whole or in part, or otherwise reproduced except as specifically permitted under U. S. copyright law, without the prior written consent of Grass Valley, Inc. , P. O. [. . . ] enables transfer and conversion even during a recording or playback. However, if this option is unchecked, the recording/playback operations may not be performed normally, therefore, we recommend that you use the system with this option checked. 24 Users Manual (Addendum for SP3) November 30, 2010 Exporting from EDIUS 6 in the MXF format Exporting from EDIUS 6 in the MXF format A project created on a PC that has EDIUS 6 installed can be exported to your T2 via FTP. You need to configure the FTP server settings in both EDIUS 6 and T2 beforehand. For more information on how to configure the FTP settings, see "Sending/receiving XDCAM sources to/from your T2 via FTP" on page 21. In EDIUS 6, you need to open the "Importer/Exporter" tree in the system settings and configure the FTP server in "MXF". For more information, please refer to the EDIUS User Reference Guide. CAUTION: If you want to use Chinese for file names, you must set the character set of file names to UTF-8 on the FTP client side beforehand. Correct file names cannot be displayed if the character sets do not match. The configuration method depends on your software. of your software. November 30, 2010 Users Manual (Addendum for SP3) 25 Chapter 2 T2 XDCAM Option 1. Click the Export button in your recorder, and then click Print to File. 2. Click MXF in the category tree on the "Print to File" dialog box. Select "MPEG2 MXF" from exporter, and then click Export. · "XDCAM HD" is not displayed if the project setting is different from the export format. You must check Enable Conversion and select an exporter. 26 Users Manual (Addendum for SP3) November 30, 2010 Workflow using XDCAM EX 4. Enter a clip name and select FTP in Destination. 5. Configure the settings, and then click OK. You can check the progress in the transfer screen on your T2. Workflow using XDCAM EX Converting XDCAM EX sources to Grass Valley HQ AVI for import You can import a file that is saved in a SxS memory card to your T2 after converting it to Grass Valley HQ AVI. CAUTION: You cannot play an XDCAM EX source or import it without converting the format. Insert an SxS memory card into your SBAC-US10. November 30, 2010 Users Manual (Addendum for SP3) 27 Chapter 2 T2 XDCAM Option 2. Select the XDCAM EX drive in the "Browse For Folder" dialog box, and then click OK. · The drive name is added to the XDCAM EX node in the Browse tab, and the clip list is displayed. Select the clip(s) you want to import, right-click on it, and then click Import. · Multiple clips can be selected. [. . . ] If no change is necessary, you do not need to use Config. From the "File format after import:" list, select XDCAM or P2 and then tap OK. November 30, 2010 Users Manual (Addendum for SP3) 59 Chapter 6 Appendix 5. Choose a bin, and then tap Start. · The import begins. You can check the progress in the transfer screen. Importing a clip with AVI conversion 1. [. . . ]