User manual GRAUPNER LIPO-QUICK-CHARGER 4

[. . . ] lithium-Polymer cells are very sensitive. For this reason they should only ever be charged in conditions when the entire charging process can be supervised constantly. warnings and safety notes · Protect the charger from dust, damp, rain, heat (e. It should only be operated in dry indoor conditions. [. . . ] the charge current required is determined by the battery capacity , and the charger detects and sets this automatically. Lithium batteries are usually charged at a charge current of 1 - 2 C, where a charge current of 1 C corresponds to the cell capacity. This makes it unnecessary to set the charge rate, and the charger therefore features no such means of adjustment. Once the specific final charge voltage for the particular battery type is reached, the charger automatically reduces the current in order to prevent the final charge voltage exceeding the permissible maximum value. Liability Exclusion As manufacturers, we at GRAUPNER are not in a position to ensure that you observe the correct methods of operation when installing, using and maintaining this charger. For this reason we are obliged to deny all liability for loss, damage or costs which are incurred due to the incompetent or incorrect use and operation of our products, or which are connected with such operation in any way. components and accessories As manufacturer GRAUPNER GmbH & Co. KG recommends to use components and accessories which have been released by GRAUPNER after checking them for suitability, function, and security. GRAUPNER assumes responsibility for these products for you. GRAUPNER does not assume responsibility for components or accessories which are not released or are produced by a different manufacturer. Also, GRAUPNER is not able to judge in every case if a product from a different manufacturer can be used without security risk. Using the charger for the first time START/STOP button OUTPUT 1-4 cells INPUT 11-15V DC Using the charger for the first time Connect your LiPo-Quick-Charger 4 to a 12 V power source of adequate capacity. The ideal power source is a 12 V car battery or other suitable lead-acid battery (Order No. Alternatively a stabilised mains PSU with a rated output of 12 - 14 V and at least 5 A can be used, e. Stand-by mode When you connect the LiPo-Quick-Charger 4 to the power source, the blue LED starts flashing at three-second intervals. Caution: if you press the START/STOP button while the charger is in charge mode, battery charged mode or error mode, the Li-Po Charger 4 reverts to Stand-by mode. charge mode Now connect a suitable genuine GRAUPNER Lithium-Polymer battery pack to the output of the LiPo-Quick-Charger 4. The pack must consist of no more than four cells. Set the potentiometer following to the desired capacity from 100 to 5000mAh. The charger is able to generate the optimal charge current for your Li-Po battery pack. 8 Using the charger for the first time If you are charging a Lithium-Polymer pack consisting of one to three cells, press the START/STOP button briefly after connecting the battery to the charger. You will hear a loud audible signal to confirm that the button was pressed, and the blue LED (for 1 - 3 cells) lights up; it continues to glow during the charge process. [. . . ] If the charger does not work at all when connected correctly to a suitable power source, and fails to produce any audible or visual indicators, remember to check the fuse (7. 5 A Blue and red LEDs Reversed polarity protection (input / output) Incorrect cell count Voltage error Circuit break (fuse) Crocodile clips Graupner BEC plug app. Environmental Protection Notes Whenever you see this symbol on a product, in the user instructions or the packaging, it means that you must not dispose of that item, or the electronic components in it, in the ordinary domestic waste when it comes to the end of its useful life. The correct method of disposal is to take it to your local collection point for recycling electrical and electronic equipment. [. . . ]