User manual GRUNDIG BEEZZ RCD 6600 SPCD

[. . . ] PORTABLE RADIO CD/MP3/WMA PLAYER Beezz RCD 6600 SPCD ENGLISH CARE AND SAFETY ________________________________________ To ensure that this device provides you with long-term satisfaction and enjoyment, please observe the following instructions: This device is designed for the playback of audio signals. Protect the device, the CDs from rain, moisture (dripping or splashing water), sand and heat. Do not leave it next to heaters or inside parked cars in the sun. Make sure there is adequate ventilation when positioning the device. [. . . ] The manufacturer accepts no liability for damage resulting from leaking batteries. Environmental note: Batteries, including those which contain no heavy metal, should not be disposed of with household waste. Please dispose of used batteries in an environmentally responsible manner. Find out about the legal regulations which apply in your area. 32 CONNECTION AND PREPARATION ___________ Additional information for units sold in the UK. Units sold in the UK are suitable for operation from a 240V ac, 50Hz mains supply. The range of multi-system receivers is built to work in most European countries. However, the mains plug and socket system for the UK differs from many European countries. This appliance has been supplied with a fitted, non-removable, approved converter plug for use in the UK. This converter plug is fitted with a 5A rated fuse. In case this appliance is supplied with a moulded 2-pin Euro plug only, which is unsuitable for UK operation, this must be cut off and immediately disposed of. An approved 13A, 3-pin UK plug should then be fitted by a qualified electrician. Note: The severed Euro plug must be destroyed to avoid a possible shock hazard should it be inserted into a socket elsewhere. If a non-rewireable 3-pin plug or a rewireable 13A (BS1363) 3-pin plug is used, it must be fitted with a 5A ASTA or BSI approved BS1362 fuse. If any other type of plug is used it must be protected by a 5A fuse either in the plug, or at the distribution board. If this type of plug becomes defective, ensure that the fuse is removed before disposal, to eliminate potential shock hazard. If it is necessary to change the fuse in the non-rewireable plug, the correct type and rating (5A ASTA or BSI approved BS1362) must be used and the fuse cover must be refitted. If the fuse cover is lost or damaged, the lead and plug must not be used until a replacement is obtained. Turn the device around to direct the antenna. Selecting the radio input source 1 Press »SOURCE« to select Tuner as the input source. Setting and storing radio stations Automatic station search 1 2 Press »7 BAND« to select the frequency band (FM or MW). Activate the station search by pressing »8« or »9« until the frequency display changes to rapid run-through. ­ The search stops when a station is found. Manual station search 1 To move the frequency up in steps, briefly press »8« or »9« several times. ­ The frequency changes in 50 kHz steps (FM) and 9 kHz steps (MW). Storing stations on station positions Up to 10 stations in the FM band and up to 10 stations in the MW band can be stored. 1 2 3 4 5 6 Press »7 BAND« to select the frequency band (FM or MW). Press »8« or »9« to select the station. [. . . ] ­ Display: »PO2« for the second preset position, »MEMORY«, »000« for the album and »FOLDER« flash. To store more files, repeat steps 2 to 4. 2 3 5 Playing back a track memory 1 2 3 4 Start the track memory by pressing » II«. ­ Playback begins with the first programmed file. Use » II« to switch to playback pause. [. . . ]